Why does the Charger light stay green when charging?
When the red light turns off and only the green light is on that indicates that the battery pack is charged and the vehicle is ready to use. If the charger light stays green and there is no red light when the charger is plugged into the vehicle and into the wall this could be caused by many things.
What should I do if my Charger light is not working?
If the charger has no output Voltage then check to see if it has a fuse and replace the fuse if necessary, then retest the charger. If the charger does not have a fuse then it may need to be repaired or replaced. Next test the Voltage of the battery pack at the charger port.
How does the Charger light work on a scooter?
Charger Light Stays Green When Charging Most electric scooter and bike battery chargers have a green light and a red light. When the charger is plugged into the vehicle and into the wall the red light indicates that the battery pack is charging, and the green light indicates that the charger is plugged into the wall.
Why does my car charger not turn on?
The battery pack’s Voltage could be tested at the charger port with the vehicle on and throttle engaged to see if it drops Voltage under load. If the battery packs Voltage is lower than the Voltage of the vehicle then that could cause the battery charger to not charge the batteries and the red light to not turn on.
Why does my car charger not recognize a dead battery?
The good battery will likely treat the dead battery as a “direct short” and things will get hot very fast as it attempts to quickly dump its current into the bad one and you can risk an explosion of battery acid. In the case with the battery connected to the running vehicle, the alternator is what is charging both batteries.
What should I do if my smart charger wont charge my battery?
Take your battery to your smart charger and hook it up again. The battery should have enough of a superficial surface charge to trigger the battery charger to start the charging process! If it doesn’t work, you can try the process a few more times before you give up.
How long does it take to charge a smart charger?
After 1-2 minutes, disconnect the jumper cables in the reverse order of how you installed them. Take your battery to your smart charger and hook it up again. The battery should have enough of a superficial surface charge to trigger the battery charger to start the charging process!
What happens if you leave your car charger on for too long?
This does not indicate that the battery is fully charged, it indicates that the battery has a surface charge. Left alone the surface charge will disappear in several hours, or you can leave the headlights on for about 30 seconds to remove the surface charge.