What does service traction control on a Chevy Suburban mean?
2007 chevy suburban “Service traction control””Stabilitrak off””Rough idle””poor shift””multiple misfire””poor acceleration”‘serial number” Mechanic’s Assistant: Is the rough idle intermittent or consistent?
What kind of Fuse does a Chevy Suburban have?
DRIVER SEAT 2 Circuit Breaker, PASS SEAT 1 Circuit Breaker, RT DOORS Circuit Breaker BCM Fuse, COOLED SEATS Fuse, DDM Fuse, DIM Fuse, DSM Fuse, REAR HVAC Fuse, RT STOP TRN Fuse, WSW PUMP Fuse ECM/THROT CONT Fuse, ENG Fuse, INJ-A Fuse, INJ-B Fuse, O2-A SNSR Fuse, O2-B SNSR Fuse, FAN CNRTL Relay]
Are there any issues with my 2007 LTZ?
I have had similar issues with my 2007 LTZ that I purchased in July 2006. No radio, Nav, Back up sensors, Traction control, stabil trac, etc. But only at start up. Short term fix is shut the truck off and open the driver door to reset the retained power, (that was your 30 min delay) then re-start. This always works for me.
Why does my GM Truck not start up?
Apparently the Data Buss runs through the radio/Nav and activates several other modules on start up, if the signal cant get through the Nav/radio, you get these types of failures. GM originally blamed it on the Nav Override that I installed, but after removing the override the issue continued. 3 months now with out an issue.
How do I Turn Off the running board on my Suburban?
After the battery has been replaced, the ASC controller goes into storage mode. To get them out of that mode, simply open all 4 doors and press the ASC controller disable button on and off 4 times. The running boards open and function properly. Thanks for everyone’s reply. I also have a 2007 LTZ with Power Running Board issues.
What are the pins on a suburban power running board?
The drivers side would have a motor and the assist step control module. It’ll have two plugs, one plug is a 6 prong plug, the other a 10 prong plug. On the 6 prong plug, two rows of 3 pins. The pin #5 (a middle pin in one of the rows and a RD/BK wire), is the battery voltage. See if you have 13 volts there.
Is the power running board on my 2007 LTZ working?
I also have a 2007 LTZ with Power Running Board issues. For about a week the driver and passenger side took turns on with board was going to work. Now for past couple of weeks only the driver side functions properly. The passenger side does not work when you open the door.