What is the power steering input shaft seal?
However, one of the most important parts that protects the inner components that drive the power steering system is the input shaft seal.
How do you remove a power steering shaft?
Lift the vehicle with a hydraulic lift or jacks and jack stands. Step 2: Remove the power steering gear from the vehicle. This step is unique to the type of vehicle you are working on, so refer to your service manual for instructions on how to remove the power steering gear from the vehicle.
How do you replace an input shaft seal?
Using a probe, pry the old dust seal from the inside of the input shaft bearing. This will typically look like an o-ring or a flat washer based on the type of gearbox you’re working on. Step 8: Drive the input shaft seal using a seal driver. The input shaft seal needs to be pushed through the bearing center.
What’s the best way to remove a gearbox seal?
Before you remove any seals, it’s a good idea to completely clean the outside of the gear box. Using a good chemical solvent, spray the outside of the gearbox completely and remove as much debris, grime and other materials from the outside of the gearbox before disassembly.
What happens when power steering input shaft seal is damaged?
When the power steering input shaft seal is damaged, hydraulic fluid can leak from the power steering input shaft, and eventually cause the system to overheat or break down entirely. Step 1: Disconnect the battery and lift the vehicle. Before removing any parts, locate the vehicle’s battery and disconnect the positive and negative battery cables.
Is there a leak in the power steering system?
This section refers to leaks found in the Ford power-assist style power steering system. With a few exceptions, it does not pertain to cars with integral-style power steering or rack & pinion systems. The most common complaint about the Ford power-assist system is fluid leakage.
What causes a pump to leak from the shaft?
1 ) LEAK: Fluid leaking from the front seal at the input shaft. CAUSE: The seal can become hard and shrink from years of wear and heat. In this case, the seal should be replaced which can be done without disassembling the rest of the pump (if you have the correct tools).
Lift the vehicle with a hydraulic lift or jacks and jack stands. Step 2: Remove the power steering gear from the vehicle. This step is unique to the type of vehicle you are working on, so refer to your service manual for instructions on how to remove the power steering gear from the vehicle.