When to remove solder from a fan override switch?
After about 3 or 4 seconds, touch the solder to the wire and lead. It should liquify and run across them. Remove the solder and iron immediately and don’t touch the wire for 20 seconds or so, to allow the solder that melted to it to harden.
How do you disconnect a fan override switch?
Use pliars to pull up the tab in the middle of the plug and it will pop right out without breaking. Now you can lift up that end of the fuse box. To disconnect the bottom, use a flat screwdriver to release the tabs all around it. With the bottom off, look for the green wire going to the fan relay.
How many rectifier connectors does a fan override switch need?
If your switch has standard blade connectors on it, pick up a pair of red female terminal connectors. If you’ve got a switch with an LED in it, it likely has 3 connectors. Otherwise it will have 2. 1 rectifier diode rated for at least 1 amp at 12V.
Why is my Polaris Sportsman 500 AWD not working?
I have had to run power to the 4wd switch on both my dads cause that crappy speedo polaris put in that year range of quad quits working. Locate the incoming wire to the 4wd switch and hook it up to a switched 12v source and bypass the speedo. You’ll have 4wd in reverse too without pushing the override button.
Why do you need a reverse overide switch on Polaris ATV?
One of the main reasons you would want to do this mod is because when you get stuck and the only way out is reverse, it is impossible to pull the ATV backwards while applying throttle AND pushing the override button.
Which is the override button on a valet switch?
In those cases the button is the valet button (also known as override button or programming button.) Also, it’s good to know that on the toggle switch style valet switches, the position which has a small notch in the metal is the OFF position. Why do you need a valet mode?
Where is the override button on a Polaris?
Pre 2003 and almost all models that do NOT have the combined override/Speedo function button. Trace wires from the override button (gray/white & gray/orange) Cut the gray/orange and tape up both ends. Cut the gray/white and tape up the end which goes to the override button.