How do I reset my w166 transmission?

How do I reset my w166 transmission?

Procedure Reset Transmission Adaptive Learning DIY

1. Turn the key to position 2. You should see all the dash lights come on.
2. Press the gas pedal all the way.
3. Wait.
4. Turn key to OFF, position 0.
5. Release the gas pedal.
6. Wait 2 minutes.
7. Start the car and drive.

What to do when your Mercedes goes into limp mode?

You may also get a check engine light if your transmission goes into limp mode. When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level.

What are the symptoms of a car in limp mode?

Common symptoms of limp mode include: 1 Reduced power 2 Speed limited to 40 MPH. 3 Engine revolutions limited to 2000 or 3000 RPM. 4 Transmission won’t change gears (Stuck in 2nd or 3rd) 5 Very slow response when pressing the gas pedal 6 Check engine light on or flashing. 7 Engine may overheat

What to do if your transmission is in limp mode?

Make sure that you are somewhere safe. Make sure that the engine has been off for at least 5-10 minutes. This will give the engine computer a few moments to sort anything out. Go ahead and verify that the transmission is still in Limp Mode. Sometimes time provides the fix.

Where is the trouble code for limp mode?

Because of this, every time when the limp mode is active, there will be a stored trouble code in the trouble code memory. Therefore, the best solution to fix the limp mode without replacing the wrong parts is to find out which this trouble code is.

You may also get a check engine light if your transmission goes into limp mode. When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level.

Because of this, every time when the limp mode is active, there will be a stored trouble code in the trouble code memory. Therefore, the best solution to fix the limp mode without replacing the wrong parts is to find out which this trouble code is.

Why does my engine go into limp mode?

The reason for this is that limp mode could be caused by a lot of different engine components in your engine bay. Therefore, the solution for this is to read the trouble code memory with an OBD2 scanner to find the problem before you are replacing any engine parts! Here is a list of different possible causes of limp-mode.

What to do when your transmission is stuck in limp mode?

The majority of the time, the problem is not as grave as you may think. If your transmission is stuck in gear and you are far away from home, try this: Pull over and turn the car off. Remove the key. Do not press the gas pedal or any other buttons on the car. Wait 20 seconds. Start the car and drive to see if it is out of limp mode.