What kind of oil does a 2009 GMC Canyon take?
Engine Oil
| Viscosity: | 0W-30 (Below -29) 5W-30 (All TEMPS) SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 6 quarts (with filter)After refill check oil level. |
| Torque: | 19 ft/lbs (Oil Drain Plug) |
How much oil does a 2015 GMC Canyon take?
Capacities
| Extended Cab (6’2” box) | Crew Cab (5’2” box) | |
|---|---|---|
| Seating (front / rear): | 2 / 2 | 2 / 3 |
| Fuel tank (gal / L): | 21 / 79.5 | 21 / 79.5 |
| Engine oil (qt / L): | 5.0 / 4.7 (2.5L) 6 0/ 5.7 (3.6L) | 5.0 / 4.7 (2.5L) 6.0 / 5.7 (3.6L) |
| Cooling system (qt / L): | 14.8 / 14 | 15.6 / 14.8 |
How to reset oil life on GMC Canyon after oil change?
Press and hold the SET/RESET button on the Driver Information Center for more than 5 seconds (on vehicles without DIC, use the TRIP reset stem for SET/RESET) Press and release the RESET stem in the lower center of the instrument panel until “Oil Life” message is displayed
What kind of oil does a GMC Canyon take?
If your Canyon is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Canyon. Most GMCs have the oil type printed on the oil cap – it will likely be 5W-20, 5W-30, 5W-40, 10W-30 or 10W-40.
How do you change the oil in a Chevy Silverado?
Turn ignition switch to ON position with engine off. Press the MODE button until the DIC reads “Oil Life Left/Hold Set To Reset”. Press and hold the SET button until the display reads “100 percent”. You will hear 3 chimes and the “Change Engine Oil Soon” message will go off.
How do you change the oil on a GMC Canyon?
For most GMCs, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a GMC Canyon oil filter wrench. If your Canyon is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Canyon.
What kind of engine does a GMC Canyon need?
7,600-lb rating requires a properly equipped Canyon AT4 Crew Cab short bed model with cloth seating, available Duramax 2.8L I4 Diesel engine and Trailering Package. Before you buy a vehicle or use it for trailering, carefully review the trailering section of the Owner’s Manual.
Why do I need an oil change on my GMC?
An oil change, which drains old oil and replaces with fresh new oil, helps to keep an engine properly lubricated. Years ago, engine oil changes were typically prescribed at a set interval, which was usually based upon mileage.
Turn ignition switch to ON position with engine off. Press the MODE button until the DIC reads “Oil Life Left/Hold Set To Reset”. Press and hold the SET button until the display reads “100 percent”. You will hear 3 chimes and the “Change Engine Oil Soon” message will go off.