What can cause misfire under load?
Engine misfires can be caused by a list of faults, but there are a few suspects that occur more than others. The primary villains are simple – spark or fuel – usually manifesting in spark plugs, plug wires, the coil(s) or the fuel-delivery system.
Why did my Mercedes-Benz C320 2001 break down?
My c320 2001 with 97k broke down. On Saturday i jumped in to the car as usual started the engine and brake faults appeared. I was suprised and switched engine off for restart having hope it will disappear.
Why is my C320 no crank and electric issues?
P2037 no or incorrect CAN message from control unit N15/3 ETC (EGS) communication fault. I was advised to check maxi fuses and front SAM fuses 52 53 54 and starter relay. All is fine and also i replaced all maxi fused. Only 60a yellow (position f6) looked overburned.
When to remove oil from Mercedes Benz engine?
If the level is between the Low and High marks you don’t need to add any more oil. If the engine oil level is below the Low mark add oil until the level shows between Low and High. If the engine oil level is above the High/Max mark, you should remove oil from the engine to avoid damage to your car.
What do you need to know about ignition coil failure?
Check your high tension leads (HT Leads). They run between the distributor and spark plugs. Ignition coil failures result in 1 or more spark plugs not receiving the appropriate amount of charge. If you have trouble starting your vehicle in the cold, this is a good sign of potential ignition coil failure.
Why does my Mercedes C class idle all the time?
This upset the vacuum lines that depend on a vacuum to maintain a steady idle. Check for vacuum leaks with a smoke generator injecting smoke into any vacuum line and see where the smoke comes out. That’s a leak that needs to be plugged.
When to fix a P0300 engine misfire?
When P0300 occurs, it should be fixed immediately as long term driving with engine misfires could cause consequential damage to your engine and catalytic converter (s). Many times, P0300 occurs when there are worn out spark plugs, spark plug wires, or a faulty ignition coil. P0300 Symptoms Check Engine Light is on
If the level is between the Low and High marks you don’t need to add any more oil. If the engine oil level is below the Low mark add oil until the level shows between Low and High. If the engine oil level is above the High/Max mark, you should remove oil from the engine to avoid damage to your car.
What happens when catalytic converter is clogged in Mercedes?
If your catalytic converter is clogged you will notice a drastic drop in fuel efficiency and real struggle getting your Mercedes to accelerate. If the cat is completely clogged your car won’t even start.