How to reset the throttle response in a Mercedes?
Turn Key to “off” position (dont remove the key) and then release the gas pedal. than wait at least 2, if not 3 minutes, for the system to reset. Keep the faith ! OK… for my own benefit, i have to ask.
Can a poor throttle response be a bummer?
Poor throttle response can be a bummer for most drivers, particularly those who relish in high-performance vehicles. Luxury imports like Porsche, Mercedes, Audi, and BMW should be driven with vigor; there is no place for throttle issues.
Why does my car have a low throttle response?
Here are three of the most common reasons for poor throttle response and what you can do to improve your vehicle’s performance. The first place that an automotive technician will likely inspect when the throttle response is low is the fuel filter. The filter is responsible for removing debris to avoid engine issues and to improve fuel economy.
Why is there no throttle response when the pedal is depressed?
If the battery reaches too low of a level and then it’s jumped to start the engine; you will experience similar issues. A reset / relearn of the ECU is required to bring the throttle response back. CEL needs to be reset with on OBD scanner. The procedure above may or may not reset the throttle position values. It did on mien about 10 times.
What causes the throttle body on a Mercedes to fail?
When there are throttle body malfunctions the wrong amount of air enters into the engine causing problems with air/fuel mixture ratio. Here is a close up picture of a Mercedes throttle body. Mercedes throttle bodies made by Bosch and VDO may fail. Luckily these units are repairable.
Poor throttle response can be a bummer for most drivers, particularly those who relish in high-performance vehicles. Luxury imports like Porsche, Mercedes, Audi, and BMW should be driven with vigor; there is no place for throttle issues.
Here are three of the most common reasons for poor throttle response and what you can do to improve your vehicle’s performance. The first place that an automotive technician will likely inspect when the throttle response is low is the fuel filter. The filter is responsible for removing debris to avoid engine issues and to improve fuel economy.
How to reset throttle possition sensor in Mercedes Benz?
First, try throttle reset procedure Turn the key to ON position. Press and hold the gas pedal for at least five seconds. Turn ignition off but do not remove the key. Remove key.
How does the gas pedal work on a Mercedes?
Since 2000 Mercedes has been using drive by wire system. Which means you press the gas pedal but there is no cable connected directly to the throttle valve. Instead, there is a potentiometer that detects the position of the gas pedal.
How to fix no throttle response when gas pedal is depressed?
Depress and hold gas pedal to floor for 5 seconds 3. Turn off ignition 4. Wait for 2 minutes 5. Reset error code 6. Turn on car and use normally Nice. I’ll see if I can clear my CEL using that. PO120 – throttle problem returns – Help!!
What causes the throttle possition sensor to stop working?
If you press the gas pedal to the floor or try to accelerate quickly or floor it, the engine stops responding, RPMs drop and it may even go into limp mode. Turn off the engine and restarting it usually fix the problem. In ost cases, the issue is caused by either a defective pedal position sensor or a bad throttle position sensor.
Turn Key to “off” position (dont remove the key) and then release the gas pedal. than wait at least 2, if not 3 minutes, for the system to reset. Keep the faith ! OK… for my own benefit, i have to ask.
Since 2000 Mercedes has been using drive by wire system. Which means you press the gas pedal but there is no cable connected directly to the throttle valve. Instead, there is a potentiometer that detects the position of the gas pedal.
Depress and hold gas pedal to floor for 5 seconds 3. Turn off ignition 4. Wait for 2 minutes 5. Reset error code 6. Turn on car and use normally Nice. I’ll see if I can clear my CEL using that. PO120 – throttle problem returns – Help!!
If you press the gas pedal to the floor or try to accelerate quickly or floor it, the engine stops responding, RPMs drop and it may even go into limp mode. Turn off the engine and restarting it usually fix the problem. In ost cases, the issue is caused by either a defective pedal position sensor or a bad throttle position sensor.