How do I reset my alarm after an oil change?
Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset. You can verify by turning the ignition off and then on again.
How does the service reminder light reset work?
The service reminder indicator is lit for two minutes each time the engine is started until it is reset after the next service. Reset is performed using a Volvo scan tool, or equivalent aftermarket scan tool. Connect scan tool to Data Link Connector (DLC) in center console, in front of shift lever.
What is the code for Volvo service reminder light reset?
System is now in DTM 4 mode. When LED comes on and stays on, the system is ready for entering codes. Code to be entered is 1-5-1. Enter first digit (1) with LED on. Wait until it comes on and stays on again, then enter the second digit (5).
How to reset service soon indicator on Cobalt Boats?
Turn the ignition to “on” don’t crank the engine. Using something small immediately push the button on the safety lanyard in 5-6 times. You will get the normal “double beep” you get at startup when you have pushed it enough times. Turn the ignition to off, and reconnect the lanyard.
How to reset service soon indicator on MerCruiser?
Remove the safety lanyard from the kill switch. Turn the ignition to “on” don’t crank the engine. Using something small immediately push the button on the safety lanyard in 5-6 times. You will get the normal “double beep” you get at startup when you have pushed it enough times.
When to reset the change oil alert on a Jeep JK?
However, Jeep introduced the feature for the 2008 model-year. The “Change Oil” alert is likely to come on approximately every 3000 miles. Changing the oil will not reset or turn off the alert; it must be manually reset. Put your Jeep in “Park” and turn off the engine. Turn the ignition to the “On” notch, without starting the engine.
Remove the safety lanyard from the kill switch. Turn the ignition to “on” don’t crank the engine. Using something small immediately push the button on the safety lanyard in 5-6 times. You will get the normal “double beep” you get at startup when you have pushed it enough times.
Turn the ignition to “on” don’t crank the engine. Using something small immediately push the button on the safety lanyard in 5-6 times. You will get the normal “double beep” you get at startup when you have pushed it enough times. Turn the ignition to off, and reconnect the lanyard.