Is the tail lamp out on a 2004 C320?
2004 C320 displays tail lamp out as well as backup light on left side. However, tail light works fine. Anyone have an idea? Thanks! Click to expand… I had this same issue a while back, did you try to remove the six pin connector and replugging it in snug? (before doing this turn your external light control knob from auto to 0).
Why is my Mercedes Benz tail lamp not working?
If you switch on the lights and leave for 5 minutes, you could see these dark areas emitting smoke. This is a condition which needs attention. It is very surprising that High profile companies like Mercedes Benz have not worked out fire retardant materials and wires for these areas.
Why are the lights not working on my Mercedes?
Lights not working – We have seen many Mercedes-Benz where one or a few lights don’t work. It can be that the left or right low beams, fog lights or turn signals may not work. You should always avoid splicing wires to get power for aftermarket HID lights, alarm or connecting a trailer hitch.
What to do if your tail lamp doesn’t work?
If that doesn’t work, remove and reconnect the bulbs tightly and then connect the six pin connector snug and turn it onto to auto, then put your fob in the ignition and turn it to till your dash lights up with pretty lights. Then push your foot on the brake to light up the bulbs in the back hopefully that works.
Why are the tail lights on my Mercedes not working?
All the fuses are clean and new. the turn signals work, but none of the rear lights work. No brake lights, no running lights, no parking lights and no reverse lights. the bulbs are all fine. And the Brake warning light is on in the car, I assume this has to do with that? Is there a tail light relay? W-1-2-3 Go! Are they plugged in?
Why is my turn signal not working on my Mercedes CLK?
Blown turn signal fuse or turn signal fuse keep on blowing. Short in the wires that provide 12 volts to the turn signal. You will need to locate the short and repair it. Check the wiring inside the headlight or tail light as the insulation of the wires may melt over time causing a short. We have seen this happen on several E and CLK class models.
Are there brake light switch problems in Mercedes?
This is a common problem on Mercedes-Benz models E-Class, C-Class, S-Class, CLS-Class, ML-Class, CLK-Class and other. Too many to list here but the most frequently defective brake light switch problems are seen with E 320 C 240 CLK 500 ML 320 ML 350 S 430 to name a few.
What to do if your tail lights are not working?
You need to remove the back off the lights ,,they only have 2 butterfly type clips to remove the backs .Then look over the bulb holders .Also pull the plug from the lights and see if there is any corrosion .Also there is an earth going to the body ,,you could clean that also and put some vasaline or grease on it then fit it back on .
What should I do about my Mercedes tail light?
Most Mercedes tail lights deal with changing the bulbs, persistent faults, lights remaining on and so on. When facing issues with the Mercedes tail lights, owners can have questions.
How to replace rear tail light bulb W203?
Learn how to replace the tail light bulbs / lamps. This DIY applies to: 2001-2007 Mercedes Benz C Class all models such as C230 C320 C240 C280 C55 . Get rid of Lamps Defective Error Message on your instrument cluster.
Where is the tail light assembly on a Mercedes C320?
The taillight assembly on the Mercedes C320 is a modular unit that houses the running light, brake light, turn signal and reverse light all in the same housing. All of the bulbs can be replaced without removing the unit from the car by accessing and removing the bulb housing portion of the unit through the access panel in the trunk.
Where can I get a tail lamp socket for a Mercedes?
At Advance Auto, we carry 17 different types of Tail Lamp Socket products for your Mercedes-Benz at competitive prices to fit your budget. Save on cost when you find your Mercedes-Benz replacement Tail Lamp Socket with us. Make sure to compare prices and take a look at the top user reviewed Tail Lamp Socket products that fit your Mercedes-Benz.
Why is my tail light bulb not working?
If you have a bulb that is out or are getting a bulb error message always inspect the electrical connector and the taillight bulb socket before just replacing the bulb. The sockets can get corrosion in them over time which can lead to a bulb not working.
Is the tail light bulb holder a genuine part?
The Genuine Tail Light Bulb Holder is the GENUINE part, in the car manufacturer’s box, as sold by the new car dealer. The Genuine Tail Light Bulb Holder is the GENUINE part, in the car manufacturer’s box, as sold by the new car dealer.
Where are the tail lights on a Mercedes Benz?
Normally the Mercedes tail lights are controlled by the rear Signal Acquisition Module (SAM) module. The SAM can be found at the lefts-side of the trunk and are generally available in aftermarket stores. Hence a diagnostic scanner may be required to check the codes in the system.
Why does the parking light stay on on my C240?
In the weeks before the battery on our C240 died, we had some odd light activity this. The front SAM control the voltage feeds to the bulb circuits, and it does not work well in low voltage situations. Is your turn indicator selected on?
How much does it cost to fix a Mercedes tail lamp?
The wires and the console burns and melts due to the quality of the wire provided. this can only be rectified by a new wiring by an electrician. If you go to the Mercedes dealer, the charges run to approximately US$ 350 plus for one console. A good auto electrician can fix this for US $ 50 for ne side.
2004 C320 displays tail lamp out as well as backup light on left side. However, tail light works fine. Anyone have an idea? Thanks! Click to expand… I had this same issue a while back, did you try to remove the six pin connector and replugging it in snug? (before doing this turn your external light control knob from auto to 0).
Normally the Mercedes tail lights are controlled by the rear Signal Acquisition Module (SAM) module. The SAM can be found at the lefts-side of the trunk and are generally available in aftermarket stores. Hence a diagnostic scanner may be required to check the codes in the system.
Lights not working – We have seen many Mercedes-Benz where one or a few lights don’t work. It can be that the left or right low beams, fog lights or turn signals may not work. You should always avoid splicing wires to get power for aftermarket HID lights, alarm or connecting a trailer hitch.
The wires and the console burns and melts due to the quality of the wire provided. this can only be rectified by a new wiring by an electrician. If you go to the Mercedes dealer, the charges run to approximately US$ 350 plus for one console. A good auto electrician can fix this for US $ 50 for ne side.