Can you replace front brake rotors on a GMC Canyon?
I just replaced my front brake rotors on my 2006 Colorado Z71 2WD I5 to Powerslot rotors. And i searched on here for a GOOD write up.. and didn’t find one. so i figured i would try to help. OH… DO NOT! USE A SLIDE HAMMER.. IT CAN DAMAGE THE BEARINGS! Sockets.. Lots of metric sockets
How to remove a front brake rotor on a Chevy Colorado?
9) Hub should be removed from vehicle by this point and you can remove the six bolts holding the old rotor on. Still be careful not to damage the sensor. 11) Installation is basically reverse of removal. 13) Put tire back on.. do other side.. and you’re done. any questions… message me.
Can you take the hub off a GMC Canyon?
Once it’s out and cleaned up you can put it back in by hand. I found it easier to take the four bolts holding the hub on almost completely off then putting a small 2×4 on it and hitting the bolts all the way around. It loosens the hub enough to take off by hand.
How do you change DOT-3 brake fluid in a Honda Canyon?
Lift the master cylinder cap and place a funnel into the reservoir. Pour DOT-3 brake fluid into the reservoir until the container is full. Remove the funnel and replace the master cylinder cap. Start the Canyon’s engine. Press the brake pedal three times, holding the pedal down for five seconds after the third depression.
I just replaced my front brake rotors on my 2006 Colorado Z71 2WD I5 to Powerslot rotors. And i searched on here for a GOOD write up.. and didn’t find one. so i figured i would try to help. OH… DO NOT! USE A SLIDE HAMMER.. IT CAN DAMAGE THE BEARINGS! Sockets.. Lots of metric sockets
9) Hub should be removed from vehicle by this point and you can remove the six bolts holding the old rotor on. Still be careful not to damage the sensor. 11) Installation is basically reverse of removal. 13) Put tire back on.. do other side.. and you’re done. any questions… message me.
Once it’s out and cleaned up you can put it back in by hand. I found it easier to take the four bolts holding the hub on almost completely off then putting a small 2×4 on it and hitting the bolts all the way around. It loosens the hub enough to take off by hand.
Lift the master cylinder cap and place a funnel into the reservoir. Pour DOT-3 brake fluid into the reservoir until the container is full. Remove the funnel and replace the master cylinder cap. Start the Canyon’s engine. Press the brake pedal three times, holding the pedal down for five seconds after the third depression.