Where is the sensor on a Mercedes W203?
Use a flat head screw driver and release the clip (red arrow) that holds the sensor housing to the intake manifold (yellow arrows). Slip the mount off the housing. Here you can see the center clip (red arrow) and the clips that hold it to the manifold (yellow arrows).
Where is the MAF sensor on a Mercedes Benz?
Make sure you only clean it with MAF sensor cleaner and that you never touch the sensor face with anything or you will destroy it. With the air filter covers off you can see the MAF sensor housing at the rear of the engine (red arrow) along with the harness (yellow arrow).
What kind of diagnostic scanner does a Mercedes Benz use?
It will scan and erase codes for the Airbag, Powertrain, Chassis, Body, Engine, Transmission and Information & Communication systems. The Carsoft 7.4 Multiplexer is designed specifically for Mercedes-Benz cars. While it can read and reset all the systems in most Mercedes-Benz models it has limited programming functionality.
How to remove the crankshaft positioning sensor from a Mercedes?
Disconnect the harness (red arrow) by squeezing the two clips together and pulling it from the housing. Use a flat head screw driver and release the clip (red arrow) that holds the sensor housing to the intake manifold (yellow arrows). Slip the mount off the housing.
What does the warning light on my C240 mean?
These models have a warning light that says (esp visit work shop). Means problem with the Electronic Stability program. 176 people found this helpful. 19 people found this helpful. My C240 ESP turn on this evening and tell me to visit workshop–Can I delay the visit till when I have cash to visit workshop and how much can it cost me to fix it
Why is the ESP light on my Mercedes C230?
My ESP warnings started after I had some major front end work done on my 2002 C230 Mercedes, and the shop had the front alignement way off so the car wanted to turn right and the steering wheel was off center. The ESP apparently tried to compensate for the steering, which is what it is supposed to do.
What kind of Screws do I need to replace my W203 ignition switch?
Remove the three T20 Torx screws holding the lower panel to the dash (red arrow) along with the one T20 screw (yellow arrow) holding the dash. Note: a previous owner had replaced some of the Torx screws with household Philips screws.