How much are brake pads for Mercedes Benz?
How much does a brake job cost? Brake pads for a Mercedes-Benz can cost anywhere between $150 per axle and $450 per axle depending on the type of brake pad desired. Mercedes-Benz Brake rotor replacement can cost anywhere between $300 – $750 for all four rotors to be replaced.
How do you change the brake pads on a CLK 350?
Remove the rear wheels from your Mercedes-Benz CLK 350 W209. Remove the brake pad wear sensor from the right brake pad. Use a hammer to remove the pin that holds the brake pads in place. As you extract the retaining pin be careful to not hit the brake heat shield. If you hit the shield you may bend it and cause it to make noise when you drive.
Where is the brake fluid located on a clk350?
Open the hood and remove the cap from the brake fluid reservoir. This will allow the brake fluid to return into the reservoir when you press the pistons into the brake caliper. Note the location on the right top corner marked with “Brake Fluid”. Location of power steering fluid, coolant, brake fluid and windshield washer.
How do you replace front brake pads on a Mercedes?
Removing the front brake pads is easy. Simply slide them away from the rotor and out of the caliper bracket. If your new brake pads did not come with the metal clips on the caliper bracket, you can reuse the old ones if they are not damaged. Be careful removing them as they will bend easily. Carefully pry them off the bracket with your screwdriver.
What should I use to clean my brake pads?
Clean the rotor and caliper by spraying it down with brake cleaner. This helps keep the brakes from becoming noisy. Be careful not to spray brake cleaner on rubber (brake line, caliper piston boot, dust covers, etc). Apply disk brake pad grease on the contact areas of the brake pad.
Do you need to replace the brake pads on a Mercedes clk350?
This guide provides instruction on how to replace the rear brake pads on a Mercedes-Benz W209 CLK350 2006-2009. These instructions apply to the following Mercedes-Benz W209 CLK models. Hammer. Yes you will need one. W209 Rear Brake pads. Ceramic Recomended 003 420 27 20 0034202720 W209 Rear Brake Pad Wear sensors. Brake pad anti-squeal grease.
Open the hood and remove the cap from the brake fluid reservoir. This will allow the brake fluid to return into the reservoir when you press the pistons into the brake caliper. Note the location on the right top corner marked with “Brake Fluid”. Location of power steering fluid, coolant, brake fluid and windshield washer.
How to replace a rear brake pad W209?
W209 Rear Brake pads. Ceramic Recomended 003 420 27 20 0034202720 W209 Rear Brake Pad Wear sensors. Brake pad anti-squeal grease. Rotors (if you plan on replacing them). Set the emergency brakes. Jack up the car using your jack. Place jack stands under the car to secure it.
What to do when you need to replace your brake pads?
Be careful not to spray brake cleaner on rubber (brake line, caliper piston boot, dust covers, etc). Apply disk brake pad grease on the contact areas of the brake pad. This is where the caliper piston meets the back of the brake pad, and where the brake pads slides onto the metal clips that snap onto the caliper bracket.