How do you remove the front drive shaft on a Mercedes Benz?
Release the Transmission and or Transcase Bracket with 8 Screws to loosen the transmission and Transcase. Snap out the front drive shaft forward by pulling on it. The pull down the rear end with the boot and rotate passed the screw. then have the transmission bracket jacked up and slide the Mercedes benz 4matic driveshaft backwards.
What kind of bolts do you need to remove a driveshaft?
Remove Driveshaft Bolts Remove the shaft differential flange mounting bolts. These bolts will be very tight so use good quality tools to avoid stripping. Some bolts can head 12 point heads as in this example which used a 13mm 12 point socket to remove.
What are the universal joints on a driveshaft?
A driveshaft can be one or two pieces with a center support bearing in the middle. There are universal joints at either end of the driveshaft which act as flex joints that allow the differential to move upward when the car contacts a bump.
How does a front driveshaft connect to a differential?
There are universal joints at either end of the driveshaft which act as flex joints that allow the differential to move upward when the car contacts a bump. A front driveshaft yoke is used to connect to the transmission while a rear driveshaft flange is used to connect to the differential.
How to remove and replace a Mercedes drive shaft?
Step by step procedure to remove the exhaust system, drive shaft, and replace the intermediate bearing — then re-assemble the car. Do it yourself, do it rig… Step by step procedure to remove the exhaust system, drive shaft, and replace the intermediate bearing — then re-assemble the car. Do it yourself, do it rig… Skip navigation Sign in
Where are the driveshaft bolts located on a Mercedes?
Locate the driveshaft bolts at the cv joint. Note that Mercedes-Benz typically uses constant velocity (CV) joints at the driveshaft and not universal joints. Remove them one at a time. Note that you may need to turn the driveshaft to get to the top bolts.
How to change the propeller shaft on a Mercedes?
Remove the splash shield. If you are changing the front propeller shaft, remove all two splash shields as it will be more comfortable to access the propeller shaft. Locate the driveshaft bolts at the cv joint. Note that Mercedes-Benz typically uses constant velocity (CV) joints at the driveshaft and not universal joints. Remove them one at a time.
How do you remove a front drive drive bearing?
Step 1: Remove the front driveshaft. The front driveshaft is attached to the transmission output shaft and connected by four bolts. On some rear wheel drive vehicles, the bearing block bolts thread into nuts that are solidly mounted or welded onto the frame.