Why is my commercial roll up door difficult to open?
If your commercial roll-up door has become difficult to open and/or close, one of several components could be the cause. Check the below list of common issues to identify the root of your problem:
What should I do if my Mercedes convertible top is not working?
Next, check the fuse for the convertible top. This is usally a 40 A fuse. If it is blown, replace it with a new fuse with the same ampere rating. Check the convertible top relay as well. Swap it with a known working relay that is identical. You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run.
What causes a roll up door to Bang?
This can cause the door to bang into the head stop or the ground. Over time, this will cause damage to the door and its components. It’s also common for commercial warehouse machinery to dent or scratch the doors during business operations. To prevent these issues, make sure to operate your commercial roll-up door with care.
Can a CLK 430 convertible top go down?
I just got my 2002 CLK 430 and can’t get the top to go down. I think I messed up as I first tried, the back of the top disengaged and popped up, the metal car portion popped up and it started to retract.
What to do when your convertible top stops working?
By the time your convertible top stops working, the leaks should be easy to identify. Inspect the hydraulic lines. Make sure they are tightly connected. The hoses should not be cracked or leaking. Address any leaks that you may find at the pump, cylinders, or solenoid. Replace any damaged or leaking o-rings.
Why is Max not marked on convertible top?
MAX, in some cases, is not marked because it is the same as the fill hole. You can’t fill them past the filler hole since the fluid will leak out, which is by design. Suppose the fluid level is too low the convertible pump operation completely to protect the motor and the hydraulic system components.
Why is my convertible top not working on my Mercedes SL500?
Start the vehicle’s engine, and let the car run while you open or close the hardtop. The hardtop does not operate if the car’s battery voltage is too low. Wait 10 minutes before trying to operate the hardtop again.
Can a soft top controller be replaced on a Mercedes?
The soft top controller (N52 ??) is surely an expensive device to replace; and if it, indeed, is directly controlling the pump motor relay — or any other relay (s) — I sure would want to keep it protected.