How do you turn the airbag off in a Mercedes B class?
It may be on the dashboard itself, in the glovebox or on the side of the dash so that you need to open the passenger door to access the switch. The switch will have two positions ‘on’ and ‘off’. To move the switch from one position to another you need a special key that you insert into the switch and turn.
Can a Mercedes airbag be reset by myairbags?
The best part of having your Mercedes original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
How to reset SRS / airbag light on Mercedes Benz?
Find the port that fits the OBD cable and plug the scan tool’s cable into this port. 2. Put the key into the ignition and turn it to the “Run” position. This is the position just before the engine starts. Look at your OBD scan tool and write down the codes it displays. 3. Check your owner’s manual for what the codes mean. 4.
When to reset Mercedes-Benz B class service Minder light?
Class B Type 246 was restyled in September 2015. Time needed: 7 minutes. When maintenance service is due, the Service due minder will appear on the display. The service interval must be reset after performed the maintenance service on your vehicle. Follow the instructions below to reset the Service Minder light on your Mercedes-Benz B-Class:
What are the fault codes for Mercedes airbags?
Call us at 888-779-9029 M-F 9-5 EST Review the table below for information on Mercedes airbag fault codes: The cause is the cable routing under the passenger seat. The wire was dressed from the factory such that the cabling to the connector was under tension.
The best part of having your Mercedes original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
Find the port that fits the OBD cable and plug the scan tool’s cable into this port. 2. Put the key into the ignition and turn it to the “Run” position. This is the position just before the engine starts. Look at your OBD scan tool and write down the codes it displays. 3. Check your owner’s manual for what the codes mean. 4.
How to set zero point on Mercedes airbag?
Here are the general steps and some important tips to keep in mind when calibrating the passenger weight sensor on Mercedes-Benz cars. When asked to move the seat FORWARD and UP. Do so but once the seat gets all the way to the front, bring it back 3 to 4 inches and down about one inch. This will set the ZERO POINT SETTING.
Can you reset the SRS module on a Mercedes?
MyAirbags is proud to offer Mercedes SRS Airbag Module Reset and Mercedes Seat Belt Pretensioner Repair services to get your Mercedes-Benz back on the road again safely.