How to troubleshoot a clunking noise in the engine?
With the engine running at idle, use the insulated plug wire pliers to remove one plug wire at a time at the spark plug location. Listen for any change in the clunking noise. If the noise disappears or lessens substantially when a wire has been removed, that cylinder will be the likely suspect for a bad rod bearing.
How to troubleshoot a clicking or popping sound in car?
Turn the wheels from lock to lock going from right to left. This will check to see if the bearing plates will make a clicking or popping noise while the vehicle is stationary. Step 3: Drive the vehicle around the block. Make turns where you can turn the steering wheel all the way in a direction.
Why does my steering wheel make clunking noises?
The struts are designed to turn with the wheels as the struts have a mounting surface for the wheel hub. While checking the struts for sounds, feel the steering wheel for any movement as if the mounting bolts to the wheel hubs could be loose making the wheels move in and out of alignment. Step 4: Drive the vehicle over bumps or potholes.
Why does my Pontiac G5 make a noise?
This noise will typically occur when the front suspension is returning to the upward position after a hard downward stroke, such as after driving through a large rut or pothole. This condition may be caused by the jounce bumper slamming into the upper spring seat because it is not retained in the correct up position.
Why does my Mercedes Benz make a clunking sound when turning right?
A few months ago I noticed a moderate “clunk” when turning right and up into my driveway. the sound would come and go. Recently had a free MB Tech Session at the local Benz dealership where they go over several points with you.
Turn the wheels from lock to lock going from right to left. This will check to see if the bearing plates will make a clicking or popping noise while the vehicle is stationary. Step 3: Drive the vehicle around the block. Make turns where you can turn the steering wheel all the way in a direction.
The struts are designed to turn with the wheels as the struts have a mounting surface for the wheel hub. While checking the struts for sounds, feel the steering wheel for any movement as if the mounting bolts to the wheel hubs could be loose making the wheels move in and out of alignment. Step 4: Drive the vehicle over bumps or potholes.
What causes a Mercedes Benz front wheel to pop?
Technician diagnosed a leaking drivers side motor mount and lower control arm bushings that had a very, very slight amount of play. He said those bushings didnt need replacement now, but maybe next year or 15k miles left on them. (roughly). He checked the ball joints and there was no up/down play in either wheel.