What is CPS on Mercedes?
Are these classic symptoms of a faulty CPS (Crankshaft Position Sensor)?
Why is my C320 no crank and electric issues?
P2037 no or incorrect CAN message from control unit N15/3 ETC (EGS) communication fault. I was advised to check maxi fuses and front SAM fuses 52 53 54 and starter relay. All is fine and also i replaced all maxi fused. Only 60a yellow (position f6) looked overburned.
Why does my car not start with a new crankshaft sensor?
A new crankshaft sensor should not have prevented the vehicle from starting. The cause of the no start issue is either related to a fuel or ignition issue that the vehicle has or something that happened during the replacement of the crank sensor.
Why did my Mercedes-Benz C320 2001 break down?
My c320 2001 with 97k broke down. On Saturday i jumped in to the car as usual started the engine and brake faults appeared. I was suprised and switched engine off for restart having hope it will disappear.
How to change the crankshaft position on a Mercedes Benz?
Unplug the electrical connector from the CPS sensor. Squeeze the connector and pull it away from the CPS sensor. This opens in a new window. Remove bolt. Remove the crankshaft position sensor. You will have either an E8 or E10 bolt that holds the CPS sensor in place.
Why does my car not start after replacing the crankshaft position sensor?
I changed out the crankshaft position sensor on my car because it was losing power while driving and the code on an AutoZone scanner said crankshaft position sensor. After replaced with a new one, car had a rougher start, no loss of power but now, two days later, it won’t start at all.
Unplug the electrical connector from the CPS sensor. Squeeze the connector and pull it away from the CPS sensor. This opens in a new window. Remove bolt. Remove the crankshaft position sensor. You will have either an E8 or E10 bolt that holds the CPS sensor in place.
Why does my car not start when I change the cam sensor?
Most of the time, this code comes up when there is a difference between the crank and cam sensors. The most common failure is the crankshaft position sensor. These fail much more frequently than the cam sensor and will cause a no start. It can also occur if the timing belt broke or jumped a tooth.
What happens when you crank the engine but it does not start?
The engine may crank, but it will not start. You may need to crank the engine longer in order to get it to start. Failed crankshaft position sensor can also impact the idling, the acceleration, or even your transmission shifting. In some cases, it can cause your transmission to go into limp mode.