How many brake discs do Euro Car Parts have?
At Euro Car Parts, we stock a huge array of brake discs for all different kinds of cars. With stock from some of the world’s best braking system manufacturers, trust us to supply brake discs that are built to last. You have selected Quantity 1 x Brake Disc . Brake discs are recommended to always be changed in pairs.
When do you need to replace your brake discs?
However, corrosion can take its toll over time, and brake discs can become dented and warped. If your car shudders when you apply the brakes, it’s often a sign that you need to get your brake discs replaced. At Euro Car Parts, we stock a huge array of brake discs for all different kinds of cars.
Which is the correct quantity for a brake disc?
Therefore it is recommended that you select Quantity x 2 . If your vehicle has specific Brake Discs for each side (e.g. some BMW M3 vehicles), please check the specification and select the correct Brake Disc (s) and Quantity.
How do you change the brake discs on a BMW M3?
Brake discs are recommended to always be changed in pairs. Therefore it is recommended that you select Quantity x 2 . If your vehicle has specific Brake Discs for each side (e.g. some BMW M3 vehicles), please check the specification and select the correct Brake Disc (s) and Quantity.
Are there any problems with the Mercedes 814?
Being exposed to road dirt, the linkage can stiffen up, with consequences for the operation of the regulator. The linkage itself is of the rigid link type, which does not normally cause problems once it has been installed. When designing the 814, Mercedes-Benz set out to reduce the number of greasing points to a minimum.
How do you change oil in a Mercedes-Benz 814?
Firstly the oil must be changed, the oil being 90 gear oil in this case. This is achieved in much the same way as for the gearbox, with two plugs, one for draining and the other for re-filling and regulating the level. The second job is to adjust the crownwheel thrust washer. This is done quite simply by using a screw and lock-nut arrangement.
Where are the king pins on a Mercedes-Benz 814?
Three are to be found on the universal joints on the driveshaft, one is on the driveshaft slider, and four are on the front-wheel king pins. The king pins are needle-bearing-mounted, and regular lubrication is important. A potential trouble spot can be found on the compressor pipe, between the pump and the air tanks.
What should I do if my Mercedes brakes are malfunctioning?
If the anti-lock system is malfunctioning, have the brake system checked and repaired as soon as possible at a qualified specialist workshop which has the necessary specialist knowledge and tools to carry out the work required. Mercedes-Benz recommends that you use a Mercedes-Benz Service Centre for this purpose.