Can BlueDriver bleed abs?
If you need to get yourself a scanner, I would seriously consider the BlueDriver® because not only can you read and clear the typical check engine light codes, you can also read and clear airbag, transmission, ABS, and other module codes (for Ford, GM, and Chrysler vehicles).
Where is the OBD connector on a Mercedes SLK?
OBD connector location for Mercedes SLK Class – R170 (1996 – 2004) You will find below several pictures which will help you find your OBD connector in your car. The OBD connector is located inside of the vehicle, above the pedals.
Where to find DTC code on Mercedes SLK 230?
The dreaded Check Engine light (arrow) stays illuminated when the car’s computer registers a diagnostic trouble code (DTC). Disconnecting the battery doesn’t erase the code. The scan tool’s cable (or a Bluetooth module on wireless systems) plugs into the OBD-II diagnostic port (yellow arrow).
Where is the fault code on a Mercedes SLK?
Disconnecting the battery doesn’t erase the code. The scan tool’s cable (or a Bluetooth module on wireless systems) plugs into the OBD-II diagnostic port (yellow arrow). On the R170 SLK, the port is located on the under-dash panel, behind the hood-release lever (blue arrow).
What are the OBDII Codes for a Mercedes?
OBDII Codes definition for car manufacturer Mercedes: B0001. B0002. B0003. B0004. B0005. B0010. B0011. B0012.
How to check Mercedes Benz SLK 230 reading fault codes?
Before plugging the scan tool into the car’s diagnostic port, make sure that the car’s battery has at least 11.4 volts with the key off and that the battery cables are clean and secured to the terminals. Plug the scan tool into the data port and turn the ignition on. For other details, refer to the scan tool’s owner’s manual.
OBD connector location for Mercedes SLK Class – R170 (1996 – 2004) You will find below several pictures which will help you find your OBD connector in your car. The OBD connector is located inside of the vehicle, above the pedals.
Is there an OBD-2 scanner for Mercedes Benz?
You can NOT diagnose them with a simple OBD-2 scanner. To read these systems and their fault codes or erase them from your Mercedes-Benz you need more advanced OBD-II scanners. Top 3 OBD-2 code readers for Mercedes-Benz have been listed under the green column below. 1. OBD II Code Reading Scanners – For ECU Only 2.
What to do if the OBD II scanner doesn’t communicate with the vehicle?
What to do if the OBD II scanner doesn’t communicate with the vehicle. TEST 1: Connect the positive DMM lead to DLC pin 4 and the negative DMM lead to the negative battery terminal, using jumper wires if necessary. Do not connect to the body or chassis ground but to the battery terminal directly.