Can you replace the distributor on a Mercedes Benz?

Can you replace the distributor on a Mercedes Benz?

You can now replace the seal on the shaft of the distributor. With the distributor out of the engine you can use a 6mm wrench and remove and replace the condenser wire that sends a signal to the CDI unit.

What are the points on a Mercedes distributor?

Some Mercedes distributors have left-pivoting points; some have right-pivoting points. Please compare the points in your Bosch distributor to the photo of points below: Determine whether your Bosch distributor has single-piece points, as early (pre-1968 or so) Bosch distributors typically have 2-piece points.

How do you remove distributor cap on Mercedes Benz?

To remove the cap, remove the two bolts holding the distributor cap to the distributor. Use a large flat head screwdriver, push the screw down and give it a half turn, it will pop up when released. You can now remove the cap and wires as one piece.

Why is the timing chain on my Mercedes 380SL not working?

In the early days, the condition intensified due in part to Mercedes wanting to lighten the valve train, as M-B reduced the timing chain width by about half with the introduction of the 380SL. This design flaw increased the failure rate of the chains, which had a direct impact on warranty. Mercedes phased the double width timing chain back.

Are there any issues with the 450SL engine?

The 450SL engine was considered robust yet like so many engines, there are issues that must be addressed. The engines can accumulate enormous mileage given proper maintenance and with careful attention to the timing chain health. A chain or chain guide problem is the usual culprit that will destroy these engines.

You can now replace the seal on the shaft of the distributor. With the distributor out of the engine you can use a 6mm wrench and remove and replace the condenser wire that sends a signal to the CDI unit.

Is the distributor on a Mercedes Benz W126 needed?

The distributor on the W126, like any distributor on any car, plays an important role in the smooth and efficient running of the engine, and while the distributor itself should last the life of the car, there are several components on or in it that wear out, need servicing or replacement over time. The first of these is the distributor cap.

How to remove distributor from Mercedes Benz R107?

Mark its spot and use a 13mm socket wrench to remove the distributor locator and fastener. Another important consideration upon removal is to lift the distributor straight out of the engine.

How to remove distributor cap on Mercedes W126?

To remove the cap, remove the two bolts (red arrows) holding the distributor cap to the distributor. Use a large flat head screwdriver, push the screw down and give it a half turn, it will pop up when released. You can now remove the cap and wires as one piece.

The distributor on the W126, like any distributor on any car, plays an important role in the smooth and efficient running of the engine, and while the distributor itself should last the life of the car, there are several components on or in it that wear out, need servicing or replacement over time. The first of these is the distributor cap.

To remove the cap, remove the two bolts holding the distributor cap to the distributor. Use a large flat head screwdriver, push the screw down and give it a half turn, it will pop up when released. You can now remove the cap and wires as one piece.