How do you remove an injector on a 1HD-T motor?
To remove the injectors on a 1HD-T motor you can use the clamp that holds them in. Remove the pipes and clamps. Drop an old 8mm bolt in the clamp bolt hole and use the clamp upside down as a lever. Tap gently on the end and it will pivot on the 8mm bolt head, levering the injector out.
Is it safe to use an injector removal service?
PLEASE BE VERY CAREFUL WHO YOU USE !!!!! We have been told by several of our customers about, and our staff have also personally come across, A Taxi Driver, A Joiner, A Carpet fitter and A Postman who whilst possibly being good at their own jobs seem to be causing havoc when attempting ours. They are all unqualified, untrained and lack
How do you get an injector out of a Land Cruiser?
Drop an old 8mm bolt in the clamp bolt hole and use the clamp upside down as a lever. Tap gently on the end and it will pivot on the 8mm bolt head, levering the injector out. Worked for me on the bottom of the world. Maybe being upside down before you start helps!
How do you replace an IC RE injector?
once you get the Valve Cover and valve cover gasket / wiring harness it easy. Remove the 10mm bolts holding the HP oil rail on, lift it off (might need a small pry bar). Then each injector is held in with a Torx bolt (T-20 or T-25). Unscrew and it will lift out the injector.
How do you remove an injector from a V-Line engine?
If you are working a V-line engine, there will be two valve covers, one on each side of the engine. Remove the bolts that secure the valve cover to the engine using a wrench. Pull the valve cover from the engine. Locate the injector fuel lines that supply fuel to the injector.
What happens when you remove the pintle caps on an injector?
By removing the pintle caps you are unrestricting the flow through the injector. Because of this modification their may be flow variance between injectors.
What’s the best way to remove a 1HD-T injector?
I strongly recommend the upside down retaining clamp method for getting the injectors out. Just put a old m8 bolt in the retaining bolt hole in the head to give a fulcrum point. The retainer will engage in the machined groove on the body of the injector, the strongest part of the body. Should only need a light tap to get the injector moving.
What is the resistance of a Duramax injector circuit?
The specified resistance at room temperature is between 0.3 to 0.4 ohms. Before measuring the resistance of any circuit, remove the negative cable on each battery. Since .3 ohms is a very small resistance, the ohmmeter leads must be clean and the meter must be perfectly “zeroed” by crossing the leads and pushing the “relative” button.