What does the warning light mean on a Mercedes Vito?
The chances are that this warning light will indicate a fault sensor like an O2 sensor, camshaft sensor, crank sensor, MAF sensor, MAP sensor or similar. Mercedes Vito/Viano 639 Mk2 SRS airbag warning light – indicates a problem within the airbag system and needs to be checked out ASAP.
What are the warning lights on a Viano Vito?
Mercedes Vito/Viano 639 Mk2 tyre pressure warning light – check your tyre pressures as one or more tyres needs to be pumped up. Mercedes Vito/Viano 639 Mk2 brake warning light – there is not enough brake fluid in the brake fluid reservoir. The braking effect may be impaired.
What does the warning light on Vito 639 SRS mean?
Mercedes Vito/Viano 639 Mk2 SRS airbag warning light – indicates a problem within the airbag system and needs to be checked out ASAP. You should use a diagnostic tool which covers the airbag system such as the the Mercedes iCarsoft i980.
What are the trim levels of the Mercedes Vito?
The new trim levels are labelled Pure, Progressive and Premium, and are available on the Vito panel van and Vito crew van only (the Vito Tourer was already sold in Pro and Select variants). You can find details of what each one offers in the Costs and Value section below.
How to diagnose a Mercedes Vito parking brake fault?
To diagnose glowplug faults you can use the Mercedes iCarsoft i980. It might not be the glowplugs but it might be the glowplug module/ECU. The i980 kit will allow you to read & clear fault codes and turn off the dash warning light. Mercedes Vito/Viano 639 Mk2 (P) PARK warning light – indicates that the parking brake is in the ON position.
What does the coolant warning light on a Vito 639 mean?
Mercedes Vito/Viano 639 Mk2 coolant warning light – the coolant symbol like this means that the temperature is too high and you should pull over immediately and not drive any further to prevent engine damage.
What should I do if I see a warning light on my Mercedes?
Switch off the engine immediately. Wait until the engine has cooled down, make sure the air supply to the radiator has not been inpaired. Avoid high loads on the engine and drive to the nearest authorised repairer ensuring the coolant temperature remains below the red marking. Caution – the cooling system is a pressurised system.
The chances are that this warning light will indicate a fault sensor like an O2 sensor, camshaft sensor, crank sensor, MAF sensor, MAP sensor or similar. Mercedes Vito/Viano 639 Mk2 SRS airbag warning light – indicates a problem within the airbag system and needs to be checked out ASAP.
To diagnose glowplug faults you can use the Mercedes iCarsoft i980. It might not be the glowplugs but it might be the glowplug module/ECU. The i980 kit will allow you to read & clear fault codes and turn off the dash warning light. Mercedes Vito/Viano 639 Mk2 (P) PARK warning light – indicates that the parking brake is in the ON position.
What kind of engine does Vito 115 CDI have?
DriveRear-wheel drive Gearboxautomatic, five-speed Gear Ratio 1st 3.600 2nd 3rd 4th 1.000 5th 0.830 Reverse gear 3.170 Axle drive ratio Mercedes-Benz OM646 DE22LA Euro 3 2.2 litre engine 2.190 4 cylinder Direct-Injection Electronic controlled Diesel with common rail 330 Nm 1.410 3.273 110 kW (150hp) 2148 cm³
Why is the EDC light on on my Vito?
Start your engine up and again have a look at the line for air in the fuel as its flowing. If see air bubbles flowing in this fuel line then thats the cause of the EDC fault. Do you have any diagrams of where to look.
Is the starter on my Vito van working?
Starter Works Fine And When The Van Was Running It Was Running Fine .it Started To Take A While To Start And This Just Got Worse Over A Few Days Till It Would Not Start At All.
Can a Mercedes-Benz Vito CDI 110 start?
There is no way of priming the van and it is not self priming, as long as the diesel filter is full of fuel the van will start. Is the EDC light on ?. Is the battery good ?. Have you read the codes with a scanner? if so what are they. 1 x 190e, 2 x vito cdi 110 many spares…. still the vito wont start…..
What should fuel rail pressure be in Vito?
Really you need it plugging into STAR to see the Live data of the fuel rail pressure, it needs to be 225+psi to start up! Also this would show if it was camshaft/crankshaft syncronization fault.
What are the relays on a Mercedes Benz Vito?
CDI, oil sensor, fuel temp sensor,CMP sensor, water temp sensor,rail pressure sensor,Crank position sensor,4 injectors, high pressure pump shut off valve, rail pressure control valve, fuel shut off valve. The only other relays are to do with lights ect ect More Fuel Problems…
Mercedes Vito/Viano 639 Mk2 SRS airbag warning light – indicates a problem within the airbag system and needs to be checked out ASAP. You should use a diagnostic tool which covers the airbag system such as the the Mercedes iCarsoft i980.
Are there any mechanical problems with the Vito?
Sorry but Vito’s where good new but very much show their Spanish build qulaity later in life.. Click to expand… Mines done over 185.000km. No rust (and it’s been through the tropics). No mechanical problems. some dicky electronics (fog lamp switches and erratic alternator dashboard light after 8 years + an faded odometer light ).