How do you fix a bent power antenna?
Cut the tail off flush with the end of the mast as shown. Insert the mast back into the antenna and tighten the nut. Unless your mast is bent or corroded you will find it will not want to stay up on its own. This is the tricky part. You will need to lightly squeeze each section of the antenna preferably with some duckbill pliers.
What should I do if my antenna is not working?
Insert the mast back into the antenna and tighten the nut. Unless your mast is bent or corroded you will find it will not want to stay up on its own. This is the tricky part. You will need to lightly squeeze each section of the antenna preferably with some duckbill pliers.
What happens if you squeeze an antenna too much?
You will squeeze each section right below where the end of the next section stops as you extend the antenna. If you squeeze too much you won’t be able to get the antenna down. Finesse this and work on each section until you can get it to lock and then collapse with light pressure.
What to do if your Mercedes power antenna fails?
Temporary Repair: If you want a reliable working power antenna for your older Mercedes you don’t have to spend big bucks. The Universal Hirschman antenna has proven to be a economical and reliable alternative. The challenge is to get it to connect and fit properly in the trunk side well.
Why is my power antenna not going up and down?
If your power radio antenna won’t go up and down anymore, the problem is either a burned-out motor or the geared cable inside the mast. Both are easy DIY fixes. You can do the entire repair in about two hours. The parts run about $25 for a new cable/mast, plus the cost of the special wrench.
Cut the tail off flush with the end of the mast as shown. Insert the mast back into the antenna and tighten the nut. Unless your mast is bent or corroded you will find it will not want to stay up on its own. This is the tricky part. You will need to lightly squeeze each section of the antenna preferably with some duckbill pliers.
How long does it take to fix a stuck power antenna?
Complete this simple fix in about 2 hours. Fix a stuck power antenna by replacing a burned out motor or bad cable/mast. You can do both in about 2 hours, and you’ll avoid the $50 – $100 dealer service fee. You need only one special tool, an antenna wrench. Tilt the bottom of the antenna away from the fender and pull the unit down and out.
Temporary Repair: If you want a reliable working power antenna for your older Mercedes you don’t have to spend big bucks. The Universal Hirschman antenna has proven to be a economical and reliable alternative. The challenge is to get it to connect and fit properly in the trunk side well.