How to troubleshoot a Contour Design circuit board?
Afterwards, lock the circuit board ribbon connector so that the circuit ribbon cable is secure, and does not move. Make sure the roller bar is placed evenly above the two metal leaf springs, and put the caps that hide the ends of the roller bar back on. Then make sure to push the caps outwards towards the ends.
Where are the Black Caps on the contour rollermouse red?
RollerMouse Red has no bar click sound and no cursor movement. Before following these instructions please contact Contour Tech support [email protected] to check warranty status. Please disconnect your RollerMouse Red from any power source before proceeding with the following instructions. Located on both ends of the bar are two black caps.
How do you troubleshoot a Contour Design wrist pad?
First, place the Free2 on a sturdy and flat surface. Remove the removable wrist pad by pulling it upwards from the sides. Put the click tension which can be found on the underside of the product to the lowest setting. If this has worked please place the wrist pads securely back onto the product, and adjust the click tension to your desired level.
How to troubleshoot a Contour Design roller bar?
If desired wipe down the bar with rubbing alcohol, but avoid any other components. Slide the roller bar back on the tube, and put the side caps back on. After pressing them down, make sure to push the caps outwards toward the ends. You should hear them click in place. If no click is heard the caps are not set correctly. 2.
Afterwards, lock the circuit board ribbon connector so that the circuit ribbon cable is secure, and does not move. Make sure the roller bar is placed evenly above the two metal leaf springs, and put the caps that hide the ends of the roller bar back on. Then make sure to push the caps outwards towards the ends.
RollerMouse Red has no bar click sound and no cursor movement. Before following these instructions please contact Contour Tech support [email protected] to check warranty status. Please disconnect your RollerMouse Red from any power source before proceeding with the following instructions. Located on both ends of the bar are two black caps.
First, place the Free2 on a sturdy and flat surface. Remove the removable wrist pad by pulling it upwards from the sides. Put the click tension which can be found on the underside of the product to the lowest setting. If this has worked please place the wrist pads securely back onto the product, and adjust the click tension to your desired level.
If desired wipe down the bar with rubbing alcohol, but avoid any other components. Slide the roller bar back on the tube, and put the side caps back on. After pressing them down, make sure to push the caps outwards toward the ends. You should hear them click in place. If no click is heard the caps are not set correctly. 2.