What happens when the ABC light is on?
If (Active Body Control) ABC light is ON or is flashing there is a good change your suspension system may be low on hydraulic fluid. When the ABC fluid level gets too low, you may also notice a humming or whining noise coming from the engine.
What to do if Mercedes Benz ABC system is not working?
Take the car to the dealer or a workshop with a Mercedes STAR diagnostic system (SDS). If the problem is not leak related, then you will need the diagnostic codes to determine what component is having the problem. “Drive Carefully” or “Visit Workshop” comes on the dash and stays.
When did the ABC system start on my Mercedes SL500?
In July of 2014, I purchased a used 2003 Mercedes SL500 with 80,000 miles on it. And within days the infamous “ABC Drive Carefully” message started appearing on the dash.
How to use ABC fluid in Mercedes Benz?
If you are using start go to ABC COntrol Unit > Acuations > Cyclically alternating actuation of the front and rear suspension struts (pitch) >F3 If Star Diagnostic is not available, use the ABC switch in the dashboard and cycle it on and off every 5 seconds. Open all your ABC fluid container and get them ready.
If (Active Body Control) ABC light is ON or is flashing there is a good change your suspension system may be low on hydraulic fluid. When the ABC fluid level gets too low, you may also notice a humming or whining noise coming from the engine.
How much does a Mercedes Benz ABS sensor cost?
Each of the four wheels has a ABS sensor. They are not difficult to replace. A quick search online yielded many choices on Mercedes-Benz ABS sensors some as low as $30, but the actual price depends on the Mercedes-Benz Model that you have.
How do you check Mercedes ABC suspension fluid?
No special tools are required to check Mercedes ABC fluid level. All you will need is a clean rag and make sure to use gloves. Turn off the engine and locate the ABC reservoir in the engine bay. Remove the dipstick.
Where is the ABC reservoir on a Mercedes Benz?
ABC reservoir is located in the engine bay, behind the driver’s side headlight. You will need to remove the large bolt, then slide bracket. This will give you enough room to remove the cap. Remove the large cap on top of the ABC reservoir. The cap has the filter integrated below the lid.