What should the EGR be on a 1990 c1500 TBI?
Check the EGR for being partially open (this may require removal to look at pintle) With engine running look at fuel integrator & block learn (fuel trim) they should be close to 128.If they are higher the computer is adding fuel.When the engine is warmed up the 0/2 should be bouncing back & forth over .500 mv.
What are the trouble codes for a GM car?
P1245Intake Plenum Switchover Valve P1250Early Fuel Evaporation Heater Circuit P1257Supercharger System Overboost P1258Engine Coolant Overtemperature – Protection Mode Active P1260Last Test Failed SCC Or Theft Detected, Vehicle Immobilized P1270Accelerator Pedal Position Sensor A/D Converter Error P1271APP Sensor 1-2 Performance
How to get a GM check engine light code?
GM Trouble Codes – Check Engine Light Codes 1 Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2 Turn the ignition on. 3 Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).
Can a bad ECM cause a bad engine?
You could have a bad ECM,but the reading with key on.engine off is correct.This is a 5 volt circuit.The sensor voltage with key on.engine should be around 4.50 to 5.00 V.Check the 3 circuits from the MAP to the ECM.Check the ignition timing,making sure you have advance at idle.
What are the fault codes for the EGR valve?
EGR valve fault codes that light up the check engine light (CEL) on your instrument cluster. P0401 EGR System Flow Insufficient. P0403 EGR Solenoid Circuit. P0404 EGR System Performance. P0405 EGR Pintle Position Circuit Low Voltage. P1404 EGR Valve Stuck Open. P1406 EGR Valve Pintle Position. Rough idle.
What happens when the EGR valve gets stuck on a GM 4.3L?
This tutorial addresses a very common problem I’ve seen on the 1987-1995 GM 4.3L, 5.0L, and 5.7L engines with throttle body fuel injection system: a stuck open EGR valve. And when the EGR valve gets stuck open, it’ll cause a rough idle condition that may hard to diagnose.
What does GM OBD I trouble code chart mean?
GM OBD I Trouble Code Chart Code Description Code 12 No distributor reference pulse (diagnost Code 13 Oxygen sensor circuit open or no activit Code 14 Engine coolant temp sensor error (high t Code 15 Engine coolant temp sensor error (low te
Where do I find the trouble code on my GMC?
When retrieving GM trouble codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.