Why does my Merc Vito 108 CDI not start?
Have a x reg merc vito 108 cdi in today which cut out and wont restart.Code read and had low fuel rail pressure. Checked for injector leak off and all seem ok.Replaced the o rings on the end of the fuel rail and still no joy. Have now replaced the high pressure fuel pump but still the van will not run.
What should I do if my Vito won’t start?
Viano 639, 651 5sp Auto. Typical of the CPS is to cut the engine when warm and enabling restart when cooled, for a while. I’m not saying it isn’t that though. Air in the fuel lines is another possible, but I wouldn’t be expecting that on an 05 and certainly unlikely after a 10 minute stop.
What to do with a Mercedes Vito camshaft?
Try using easy start to start it one morning give it a spray and then turn it over. if it goes then it could be as simple as the fuel line seals but could also be the fuel pumps. If you need any other help check out Your one stop shop for all your mercedes vito New and Used parts and spares or give me a shout on the number on the site Mark
What are the relays on a Mercedes Benz Vito?
CDI, oil sensor, fuel temp sensor,CMP sensor, water temp sensor,rail pressure sensor,Crank position sensor,4 injectors, high pressure pump shut off valve, rail pressure control valve, fuel shut off valve. The only other relays are to do with lights ect ect More Fuel Problems…
Is the starter on my Vito van working?
Starter Works Fine And When The Van Was Running It Was Running Fine .it Started To Take A While To Start And This Just Got Worse Over A Few Days Till It Would Not Start At All.
Can a Mercedes-Benz Vito CDI 110 start?
There is no way of priming the van and it is not self priming, as long as the diesel filter is full of fuel the van will start. Is the EDC light on ?. Is the battery good ?. Have you read the codes with a scanner? if so what are they. 1 x 190e, 2 x vito cdi 110 many spares…. still the vito wont start…..
Why does my Vito W639 engine not start?
Pulled the key out put it back in and it started. Over the next couple of days used it a few times no problems. The mechanic had not reset the assyst service system so took it back. Came home no problems. next day went to start all lights, locks etc worked but would not start.
CDI, oil sensor, fuel temp sensor,CMP sensor, water temp sensor,rail pressure sensor,Crank position sensor,4 injectors, high pressure pump shut off valve, rail pressure control valve, fuel shut off valve. The only other relays are to do with lights ect ect More Fuel Problems…
How do you seal a Mercedes diesel injector?
Once the injector is fully inserted, with the fuel connection pointing to the fuel rail, add the clamp and loose-fit the clamp bolt to hold things in place.
Is the No 2 injector seal leaking in a Mercedes Sprinter?
In a recent Mercedes Sprinter engine replacement (Used engine fitment) it was noticed at the time of purchase that there was an issue with No.2 Injector seal leaking.
Why does my Mercedes Benz Vito not start?
It turned out to be a broken wire to the injector. If the edc light is on then it will not start because it thinks there is a fault either with the wiring, air in the fuel, water in the fuel or lack of fuel pressure. Got my Vito back yesterday.
How big is the injector seal ring on a Mercedes?
The extended threaded shank length, 85.83mm long, 6.0mm dia., 8.8 grade, factory hold down bolt, hold down pawl and injector seal ring are identical part numbers for both the 5 cyl. and 6 cyl. engines.
Starter Works Fine And When The Van Was Running It Was Running Fine .it Started To Take A While To Start And This Just Got Worse Over A Few Days Till It Would Not Start At All.
What should fuel rail pressure be in Vito?
Really you need it plugging into STAR to see the Live data of the fuel rail pressure, it needs to be 225+psi to start up! Also this would show if it was camshaft/crankshaft syncronization fault.
Try using easy start to start it one morning give it a spray and then turn it over. if it goes then it could be as simple as the fuel line seals but could also be the fuel pumps. If you need any other help check out Your one stop shop for all your mercedes vito New and Used parts and spares or give me a shout on the number on the site Mark
Are there any problems with the Mercedes Vito?
Common Mercedes Vito ECU faults are. Start Error ( Immob Problem! ) If you need any help with these situations please contact me to save yourself alot of time and money! Sometimes you don’t need to change all of the ECU/WSP/Key if its only the ECU at fault!!:thumbsup:
Why is the EDC light always on in my Vito?
The wires in question run from a plug attached to something on the left had side of the engine (as you look at it) down by the alternator up to the wiring loom which runs across the rocker cover, not sure quite where they go to. Click to expand… Me too, i have same problem, EDC light always on.
Why does my Vito CDI 110 2000 shut off?
Hi My Vito CDI 110 2000 has Shut off Fault Code, Boost Pressure Code. 7.5a ECU Fuse causes grey smoke rough running when inserted. Merc Star Can not communicate with the CDI. Van starts and runs ok without the 7.5a fuse but in limp mode. Help.
Common Mercedes Vito ECU faults are. Start Error ( Immob Problem! ) If you need any help with these situations please contact me to save yourself alot of time and money! Sometimes you don’t need to change all of the ECU/WSP/Key if its only the ECU at fault!!:thumbsup:
The wires in question run from a plug attached to something on the left had side of the engine (as you look at it) down by the alternator up to the wiring loom which runs across the rocker cover, not sure quite where they go to. Click to expand… Me too, i have same problem, EDC light always on.
Why does my Vito car not start up?
If it starts with a Sniff of Easy, Then its likely to be your High pressure fuel pump. Really you need it plugging into STAR to see the Live data of the fuel rail pressure, it needs to be 225+psi to start up! Also this would show if it was camshaft/crankshaft syncronization fault.
What causes soot build up in Mercedes engine?
Wrong engine oil can cause excessive soot build up. Luckily, the regeneration process can be initiated manually, using an appropriate diagnostic tool. In most cases, this will purge a clogged DPF. Mercedes, like many diesel cars, uses a DPF Exhaust Pressure Sensor to determine how much does the DPF restrict the exhaust flow.
Really you need it plugging into STAR to see the Live data of the fuel rail pressure, it needs to be 225+psi to start up! Also this would show if it was camshaft/crankshaft syncronization fault.
Wrong engine oil can cause excessive soot build up. Luckily, the regeneration process can be initiated manually, using an appropriate diagnostic tool. In most cases, this will purge a clogged DPF. Mercedes, like many diesel cars, uses a DPF Exhaust Pressure Sensor to determine how much does the DPF restrict the exhaust flow.
Is there a problem with my Vito long?
Vito Intermittent Starting Problem ! I have a 2004 111CDi Vito Long with 76K miles and have been experiencing intermittent starting problems for about a month. In the morning it starts first time and I can invariably stop and start several times during the day without the problem.
Why does my Mercedes Vito have a start error message?
Have you got a Mercedes Vito van with a start error messageon the instrument cluster? The start error is usually down to the battery going flat on your Mercedes Sprinter or Vito. This causes the ECU and the immobiliser moduleto have a problem, which in turn stops you from starting your Mercedes van.
Vito Intermittent Starting Problem ! I have a 2004 111CDi Vito Long with 76K miles and have been experiencing intermittent starting problems for about a month. In the morning it starts first time and I can invariably stop and start several times during the day without the problem.