Can a Mercedes-Benz Vito CDI 110 start?

There is no way of priming the van and it is not self priming, as long as the diesel filter is full of fuel the van will start. Is the EDC light on ?. Is the battery good ?. Have you read the codes with a scanner? if so what are they. 1 x 190e, 2 x vito cdi 110 many spares…. still the vito wont start…..

Why does my Mercedes Benz Vito not start?

It turned out to be a broken wire to the injector. If the edc light is on then it will not start because it thinks there is a fault either with the wiring, air in the fuel, water in the fuel or lack of fuel pressure. Got my Vito back yesterday.

What are the relays on a Mercedes Benz Vito?

CDI, oil sensor, fuel temp sensor,CMP sensor, water temp sensor,rail pressure sensor,Crank position sensor,4 injectors, high pressure pump shut off valve, rail pressure control valve, fuel shut off valve. The only other relays are to do with lights ect ect More Fuel Problems…

When did the Mercedes Benz Vito come out?

The autumn of 1996 saw the arrival of the original Vito in the UK and the vehicle quickly established a strong following among van buyers. Badge prestige and an options list brimming with lavish add-ons meant that the Vito appealed to retail customers for whom cost was less important than comfort and the ‘right’ image.

What happens if you don’t turn the ignition key?

Sometimes the ignition key won’t turn or rotate. If that happens the vehicle won’t start, the steering wheel won’t turn and it won’t shift into gear. On a late 90’s or early 2000 GM vehicle this is the way to get it apart so you can replace the tumbler.

What to do if your Honda Key wont turn in?

Your local Honda dealership are very unlikely to be able to, or want to, replace the entire ignition unit which involves changing the cylinder locks and the ignition housing. As a result, you will end up having two different keys; one for the new ignition and one for the vehicle locks.

What’s the best way to turn the ignition?

Then insert the key into the ignition and gently jiggle the key without putting much pressure on the key as do this. As the lock pins on the tumbler wear out it will get harder and harder to turn the ignition of your car. Here is a video that will help you understand this problem.

When did Honda Odyssey key not turn in?

Honda Pilot ignition will not turn from 2003 t0 2013 Honda Odyssey key stuck in the ignition from 2003 to 2013 Honda Insight key sticks in ignition from 2005 to 2012 Honda Element ignition will not turn from 2003 to 2011 Honda Crosstour steering wheel locked from 2010 to 2012 Honda Civic ignition problems from 2003 to 2013

What kind of engine does a Mercedes Vito have?

The real change came in 1999 when Mercedes released a double overhead camshaft 2.2-litre common rail turbo diesel engine that transformed the Vito. The 108 CDi delivered 60 kW at 3800 revs, and 200 Nm at 2400 revs, which gave the base van smooth purposeful performance and miserly economy.

What kind of car is the Mercedes Vito?

The Vito is a mid-sized one-tonne payload front-wheel drive van. With its sloping bonnet and windscreen, and neat van proportions, the Vito is an attractive light commercial, one that presents your business well when out and about on the job.

It could be a few things really Camshaft sensor Fuel line seals Injectors fault Lift pump or High pressure fuel pump My guess is its a seal in the fuel lines maybe the one that seals the return line from the fuel rail..

What to do with a Mercedes Vito camshaft?

Try using easy start to start it one morning give it a spray and then turn it over. if it goes then it could be as simple as the fuel line seals but could also be the fuel pumps. If you need any other help check out Your one stop shop for all your mercedes vito New and Used parts and spares or give me a shout on the number on the site Mark

Why does my Vito car not start up?

If it starts with a Sniff of Easy, Then its likely to be your High pressure fuel pump. Really you need it plugging into STAR to see the Live data of the fuel rail pressure, it needs to be 225+psi to start up! Also this would show if it was camshaft/crankshaft syncronization fault.

What kind of fuel injector does a Mercedes Benz use?

NEW BOSCH DIESEL FUEL INJECTOR MERCEDES BENZ VITO 108CDI 638 08/1999-2002 2.2L . 613070088780 COMMON RAIL INJECTOR MERCEDES BENZ SPRINTER/ VITO 2.1 – 2.7LTR …

What should I do if my Mercedes injector is not working?

Once identified the work can begin – Run the engine until nice and warm then turn it off and remove the keys. Remove the turbo supply hose to the inlet manifold and split the composite intake manifold by removing the pins that secure it to the lower section.

What to do if you have a diesel injector problem?

Start the engine and watch for the darkening/spotting of the brown paper with diesel spray, this will indicate quite clearly where the problem lies. Once identified the work can begin – Run the engine until nice and warm then turn it off and remove the keys.

What to use to clean Mercedes diesel injector seat?

Use a torch to inspect the injector seat in the cylinder head, it will likely be blackened and carbonised, this needs to be cleaned off and in severe cases re-cut to present a perfect sealing surface. I have in the past had great success using a wooden dowel, rather like the ones used on a valve grinding hand tool.

What kind of injector do I need for a 2.2 litre diesel?

This washer is the standard CDI injector seal used on all modern Honda 2.2 litre diesel engines (More info on the Honda seal – here ). I personally have had great success using the Honda part as they seem to be made from a superior material and appear more compressible thus making a better seal against any slight face imperfections.

Is the Mercedes Benz Vito front wheel drive?

Is a car-like cabin and drive enough to justify the revised Vito’s ste… A new front-wheel drive variant, leaner and greener power and enhanced…

Where is the WSP on a Vito CDI 110?

the WSP is located behind the clocks and the plug that plugs into it is GREEN. WHat is up with your Immobiliser, As I fix most Vito START ERROR or immob box corruption! 1 x 190e, 2 x vito cdi 110 many spares…. the WSP is located behind the clocks and the plug that plugs into it is GREEN.

Where is the CDI immobilizer on a Vito?

Is it supposed to be behind the dash cluster on the drivers side (RHD), sliding in a little bracket, because if it is I have a piece of foam block there, with a plug nearby that is black and square. Also my key doesn’t look like it has a chip in it. So would it be likely that my Vito doesn’t have an immobilizer in it?

Can a German glow plug make a Mercedes glow?

No amount of power will make it glow. One note is that the only glow plug that worked was the German plug in the number one cylinder. Somebody in the past had put Autolite plugs in the other 5 cylinder and they were ALL bad. Use quality OEM made parts on these cars!

What are the features of the Mercedes Vito?

The Mercedes-Benz Vito is available with a new set of equipment: The Vito SPORT Line. It contains sporty design elements and numerous additional equipment that guarantees a maximum of driving dynamics. The new Vito SPORT sets dynamic design accents. Maximum dynamics with the new Vito SPORT.

How to use glow plug on Mercedes Benz Vito?

Pull the glowplug out with pliers push some paper towel down into the smaller hole. Purchase a helicoil kit off the internet it&8217s a 10 X 1.0 mm (fine) thread. Place a glowplug in the next cylinder sticking out as far as possible for alignment drill tap & helicoil the hole try to suck as much swarf

Is the Mercedes Benz Vito available in Australia?

Please contact an authorised Mercedes-Benz Vans retailer for specific information on vehicles and features available in Australia. Product changes may have been made since production of this content. Available in three lengths: short-wheel base 1. Mid-wheel base and long-wheel base

How long is the warranty on a Mercedes Vito?

Customers should make additional enquiries based on the specifics of their vehicle to obtain accurate payload figures. ^Warranty is applicable to new Mercedes-Benz Vito vehicles first registered on or after 1 January 2020 for 5 years from the date of first registration or until the vehicle has travelled 250,000 kilometers, whichever occurs first.

What should I do about common rail pressure on my Vito 115?

I have a Vito 115 CDI 2005 model. Problem with common rail pressure.Engine maintenance light goes on and Vito goes into limp mode. Following has been done: 1. Rail pressure sensor replaced, Diesel tank cleaned, fuel line cleaned, Fuel filter replaced, Diesel pump and injectors calibrated.

Are there any mechanical problems with the Mercedes Vito?

No rust (and it’s been through the tropics). No mechanical problems. some dicky electronics (fog lamp switches and erratic alternator dashboard light after 8 years + an faded odometer light ). It’sbeen driven around australia and at one stage was doing round trips of 3600km every week. It never missed a beat.

What kind of engine does Vito 115 CDI have?

DriveRear-wheel drive Gearboxautomatic, five-speed Gear Ratio 1st 3.600 2nd 3rd 4th 1.000 5th 0.830 Reverse gear 3.170 Axle drive ratio Mercedes-Benz OM646 DE22LA Euro 3 2.2 litre engine 2.190 4 cylinder Direct-Injection Electronic controlled Diesel with common rail 330 Nm 1.410 3.273 110 kW (150hp) 2148 cm³

How old is a Mercedes Vito CDI Van?

Mine is just nearly 5 years old and although ive just had a full paint there was no rust under the paint only dents from the previous owner. Also as for the engine again treat it right and all modern engines should give a least 200k without much chew.

What are the dimensions of a Vito panel van?

Vito Panel Van. 3 vehicle lengths: compact (standard) 4895 mm, long 5140 mm and extra-long 5370 mm. Load compartment volume of up to 6.6 m³ in the extra-long version. Space for up to 3 Euro pallets in the long and extra-long version, loading possible through the rear door and the sliding door.

What kind of floor mats do Mercedes Benz use?

Our OEM floor mats are crafted exclusively for Mercedes vehicles, giving you ultimate peace of mind that every inch of your carpeting will be perfectly preserved. As easily as they’re installed, they’re also easily removed for quick cleaning to keep the cabin looking pristine day after day.

How are Mercedes Benz parts made to work?

They’re engineered specifically to function with their fellow parts and systems, and they’re constructed from the finest materials available. They’re also subjected to rigorous testing, which means each part comes fully certified. In the end, you can be sure that your vehicle will perform up to its potential, mile after mile.

Why is the EDC light still on in my Mercedes Vito?

The glow plugs have current for the heat up process and then there is no currnet to them after a couple of seconds so performing properly but the light remains on. Two of the injectors were “chuffing” so I recut the seats, new copper washers and bolts and that appears to have fixed that problem but the EDC light remains on.

How tall is a Mercedes Benz Vito van?

How high is a Mercedes Vito van? The Mercedes Vito has a vehicle height of 1,910 mm and a load height of 1,391 mm. Maximum load volume for the L3 variant is 6.6 cubic metres. What is the difference between a Mercedes Vito und Viano?

What kind of engine does a Mercedes Vito 2001 have?

The Mercedes-Benz Vito 2001 is available in Diesel and Regular Unleaded Petrol. Engine sizes and transmissions vary from the Commercial 2.2L 5 SP Manual to the Commercial 2.2L 4 SP Automatic.

How much does a Mercedes Benz Vito cost?

The Mercedes-Benz Vito 2001 prices range from $3,800 for the basic trim level Commercial Vito 108CDI to $7,700 for the top of the range Commercial Vito 112CDI. The Mercedes-Benz Vito 2001 is available in Diesel and Regular Unleaded Petrol.

Is the starter on my Vito van working?

Starter Works Fine And When The Van Was Running It Was Running Fine .it Started To Take A While To Start And This Just Got Worse Over A Few Days Till It Would Not Start At All.

What should fuel rail pressure be in Vito?

Really you need it plugging into STAR to see the Live data of the fuel rail pressure, it needs to be 225+psi to start up! Also this would show if it was camshaft/crankshaft syncronization fault.

Navigation