Where do I put the cold start injector on my MR2?
2. remove cold start injector from intake manifold but do not disconnect the gas line. place the injector over a coffee can or something of the sort. 3. jump the Fp and B+ terminal on the diagnostic connector. (remember to have key in the “on” or “acc” position.
When is engine is cold it studders and misses but when warm?
When engine is cold it studders and misses but when warm When the engine is cold it studders and misses but when warm it runs great and it only happens when I start it and go but if I let it warm up before I go itll run like it should what would cause this issue when the check engine light isnt on and there is no codes on a computer?
How does the cold start valve work in a Mercedes Benz?
When the cold start valve opens, the pressure above the control plunger is reduced. This also enriches the mixture from the main fuel injectors because the plunger can move farther for the same air flow, allowing the air flow plate to displace farther, and allowing more fuel to flow from the main injectors for the same airflow.
Where is the cold start timer on my MR2?
Whats the timer? the cold start timer is located on the thermostat housing. it is the vertical connector just south of the thermostat. i believe the connector is blue.
Where is the CSI switch on a MR2?
Click to expand… not according to “the big green book”. the csi switch, is “screwed into the top of the thermostat housing” as quoted from the haynes manual for the 1985 to 1987 mr2’s. and those are just what i’ve had to work on that directly correlate with the CSI (and other stuff too).
What are the symptoms of a bad cold start injector?
$0.00 1 Hard Starting One of the first symptoms typically associated with a bad cold start injector is a problem starting the… 2 Decrease in MPG A decrease in fuel efficiency is another symptom of a bad or failing or failing cold start injector. 3 Engine performance issues More