Where is the starter battery on a Sprinter van?
You’ll always be able to start the van and drive. It does this by using a relay under the driver’s seat. It’s the big black box to the right of the picture with the two copper bars going in to it. The red cable at the front is from the starter battery.
What should I do if my sprinter wont start?
Inspect the o-ring and back up washer on the end of the regulator. If you have a split or tear in this o-ring you just found your problem. Replace the o-ring and reinstall. Dont let your dealer try to sell you the whole regulator for $300 the o-ring only kit is part number is 05175439AA.
What are the codes on a 2011 sprinter?
Good morning, I have a 2011 sprinter that will not start, the codes pulled are 118900 current, 155c00 stored, 15b700 current 16ce00 current.We’re do I start? Help… read more Keiphun Sowell Owner Brothers Restoration/Troubleshoot
How does the aux battery in a sprinter work?
This second battery should be of exactly the same type as your starter battery (the one under the driver’s feet). The aux battery works by connecting to the alternator and the starter/engine battery whenever the engine is running, and then disconnecting whenever the engine is off.
Inspect the o-ring and back up washer on the end of the regulator. If you have a split or tear in this o-ring you just found your problem. Replace the o-ring and reinstall. Dont let your dealer try to sell you the whole regulator for $300 the o-ring only kit is part number is 05175439AA.
Why does my Mercedes not start when I charge the battery?
This Mercedes-Benz is not starting because of a low battery. In this case, what you need to do is trickle charge your battery using any of these 12 volt battery trickle chargers. If you need help read this article on How to charge a Mercedes-Benz the right way. Mercedes won’t start, and it’s not the battery.
What kind of pressure crank does sprinter have?
This van is dead, makes no smoke or fumes when cranking. According to two scanners (SDS MB factory tool, and Snap on Solus) I have 5000PSI pressure cranking. If I unplug the fuel pressure sensor and crank for about 20-30 seconds I can get it to hit on what sounds like one cylinder and make a little bit of fumes.
What happens when you unplug fuel pressure sensor in sprinter?
If I unplug the fuel pressure sensor and crank for about 20-30 seconds I can get it to hit on what sounds like one cylinder and make a little bit of fumes. The actual pressure matches the desired after 10-15 seconds of cranking. The actual pressure gradually builds and when you quit cranking it gradually drops.