Where does a high mounted stop lamp go on a vehicle?
A lamp is not fitted in a central high-mounted position. 4. A lamp fitted to a group M or N vehicle, except one that does not have a rear window, or that does not have a rear window visible from the rear, has an illuminated surface that is lower than 150mm below the bottom edge of the rear window. 5.
Do you have to have a stop lamp?
The permitted lamp is not required to operate, but if it does operate, it must meet the equipment, condition and performance requirements, although it may be obscured.
What are the lights on a Mercedes Benz W204?
Ambient Lighting/ Central Locking / Cortesy Lights / Warning Lamps / Exterior Mirror Function / Power window, front / Seat adjustment, front / Steering wheel adjustment / Switch illumination
What are the symptoms of a bad backup light switch?
1. Reverse lights function intermittently 2. Reverse lights stay on at all times 3. Reverse lights fail to come on at all Average rating from 130,525 customers who received a Vehicle Body Electrical and Lighting Inspection. The backup light switch is the electronic switch on a vehicle that is responsible for activating the vehicle’s reverse lights.
Why does my Mercedes Benz not have reverse lights?
The NSS is adjusted correctly when the car starts in both P and N. If not it will not light up the reverse lights and you won’t be able to tell if it was the switch or the harness. The Transmission Wiring Harness? The harness was my next and final check as the only other part would be the Main Floor Harness and that was in good condition.
How does the backup light switch work on a truck?
The switches work by activating the lights when the transmission is put into reverse gear. In some vehicles, such as large trucks or vans, the backup light switch may also activate the backup alarm, which beeps to notify pedestrians and other drivers that the vehicle is traveling in reverse.
How to fix no back up / no reverse lights?
If you keep loosening the bolts you will not be able to get the ratchet off the bolt or the bolt out. Once loose remove the bolt by hand ( two gloved fingers). Do your best not to move the switches lever position and the NSS is pulled away fron the Transmission towards the insulation and then down.