What is anti-theft protection?
Anti-Theft Protection is a vehicle theft deterrent system designed to help deter potential thieves from stealing a vehicle, and provides consumer benefits in the event of a covered loss.
What happens if I dont turn on my anti theft system?
The key you are using may not have the chip required to start your car. If the anti-theft system has locked up your engine, you won’t be able to start it. You’ll have to disable it with these steps. Step 1: Check for the anti-theft light. It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position.
How does anti theft system work on Mercedes Benz?
It has nothing to do with the anti theft system in the car. When a COMAND unit is installed into a vehicle (whether during production or as a replacement) it is equipped with a PIN. This PIN will be associated to the VIN and relies on the communication network within the vehicle for validation.
Where do I find anti theft protection activated?
On the way to the cottage the Audio 20 screen displayed the message: Anti-Theft Protection Activated – Please visit your nearest Mercedes-Benz dealer. This message appeared on both the smaller dash display and the larger Audio 20 display. I could not access phone, radio, media, system or anything else.
What to do if your car anti theft light is not blinking?
Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two. This gives the system time to reset or you won’t be able to start your car. Step 4: Start the engine. Attempt to start your engine.
Why does my anti theft system not work?
My car has an automatic transmission. Your anti-theft system (pass-lock) may have a fault or it may be the key itself. The keys have a chip embedded in them. When inserted into the ignition, the alarm system looks for codes from the key. Try another key if you have one. If it starts, then the first key is bad and has to be replaced.
It has nothing to do with the anti theft system in the car. When a COMAND unit is installed into a vehicle (whether during production or as a replacement) it is equipped with a PIN. This PIN will be associated to the VIN and relies on the communication network within the vehicle for validation.
On the way to the cottage the Audio 20 screen displayed the message: Anti-Theft Protection Activated – Please visit your nearest Mercedes-Benz dealer. This message appeared on both the smaller dash display and the larger Audio 20 display. I could not access phone, radio, media, system or anything else.
How to program the Chrysler anti theft system?
If you get a new key from the dealer, here’s how to program the system yourself. 1) Insert one good key in the ignition switch and turn it to ON. Leave in ON for 3-secs., and then turn it to OFF. 2) Insert the second good key and turn to ON. You must insert both keys withing 15-secs.