Where can I find the trunk lock cylinder?
Use the trunk release lever normally found on the floorboard of the driver’s side of the vehicle to pop open the trunk door. Using a trim removal tool, pop out each plastic retaining rivet to free the trunk liner. With the liner removed, you will have access to the back of the trunk door, and should be able to locate the trunk lock cylinder.
How do you remove a lock cylinder from a car?
The lock cylinder usually comes out by gently pushing it out from the inside. You may need to rotate the cylinder as you are removing it to clear the mounting hole. Step 1: Install the new lock cylinder. Feed the new lock cylinder into the hole in the trunk door, rotating as necessary to get it to seat properly.
How do you drill a bolt out of a cylinder head?
Line up the tool with the hole and use the larger size bushings and work your way down the sizes to hone in on the exact dead center of the bolt and then secure the tool via other bolt holes or C-clamps. Then go to the took kit and use the correct tap drill (+.005 larger) in the hand drill.
What’s the difference between a trunk and a chest?
Trunk (luggage) They are most commonly used for extended periods away from home, such as for boarding school, or long trips abroad. Trunks are differentiated from chests by their more rugged construction due to their intended use as luggage, instead of the latter’s pure storage.
How do you remove a trunk liner from a car?
Step 1: Pop the trunk and remove the trunk liner. Use the trunk release lever normally found on the floorboard of the driver’s side of the vehicle to pop open the trunk door. Using a trim removal tool, pop out each plastic retaining rivet to free the trunk liner.
Use the trunk release lever normally found on the floorboard of the driver’s side of the vehicle to pop open the trunk door. Using a trim removal tool, pop out each plastic retaining rivet to free the trunk liner. With the liner removed, you will have access to the back of the trunk door, and should be able to locate the trunk lock cylinder.
The lock cylinder usually comes out by gently pushing it out from the inside. You may need to rotate the cylinder as you are removing it to clear the mounting hole. Step 1: Install the new lock cylinder. Feed the new lock cylinder into the hole in the trunk door, rotating as necessary to get it to seat properly.
How do you replace a retaining bolt on a trunk lock?
Replacing the retaining bolt is pretty straightforward; just hand tighten the bolt. If you have a retaining clip, you will likely need gloves and needle nose pliers to line it up and press it into position without cutting yourself or hurting a knuckle.
What happens if your trunk lock cylinder is faulty?
The trunk lock cylinder on your vehicle is responsible for triggering the latch mechanism that opens the trunk when you turn the key. A faulty lock cylinder can be a security issue for you and your car.
Replacing the retaining bolt is pretty straightforward; just hand tighten the bolt. If you have a retaining clip, you will likely need gloves and needle nose pliers to line it up and press it into position without cutting yourself or hurting a knuckle.
How do you change the trunk lock actuator?
The steps below will outline how to change the trunk lock actuator on your vehicle in the event that it fails. Step 1: Access the trunk and locate the trunk lock actuator. Chances are if you need to replace this part, then one or more of the normal methods of popping the trunk are not functioning.
What should I do if my trunk lock is not working?
This can usually be done by hand, but if you are having trouble, use a flathead screwdriver or a trim panel removal tool. The trunk door carpeting may need to be removed as well, if your vehicle has any. Pop out the plastic retainer clips with the trim panel removal tool and set the carpeting aside.