Why does my truck only go in reverse?
This could likely be due to a faulty computer that controls the transmission, a faulty transmission solenoid, or another issue with your transmission. If there is an issue with your solenoid you could be experiencing slipping gears or a transmission that won’t shift into gear properly at all.
Is the GM Turbo 350 a good transmission?
The Turbo 350 was known as a durable transmission and was used extensively by GM. However, over time the Turbo 350 will develop problems, as with any type of transmission, but troubleshooting this transmission is easier than many other types due to its basic design.
What causes a 350 Turbo transmission to shift?
Also check the planetary pinions, the sun gear, and both the front and rear internal gears for tooth damage. Finally, check the condition of the engine’s two motor mounts. If one or both of the motor mounts are damaged, the engine will cause the transmission to shift, which will in turn cause the transmission to produce noise.
When did the General Motors 350 Turbo come out?
350 Turbo Transmission Troubleshooting. by John Stevens J.D. The Turbo-Hydramatic 350, commonly referred to simply as the “Turbo,” was a three-speed automatic transmission first produced by General Motors in 1969.
Why are the clutch plates on my 350 not working?
If the problem persists, the forward, intermediate and direct clutch plates may be slipping. If so, the face of the plates will appear burnt. To avoid damaging the replacement plates, make sure that the seals and oil rings are in good condition, as these are the most common causes of burnt clutch plates.
What does it mean when your truck has no forward gears?
Suddenly, you have no forward gears in your vehicle. No signs of transmission issues before this. Your truck works strong in reverse, but no forward at all. It just feels like you’re in neutral. I read a lot of posts that scared me about how the planets and other expensive sounding parts of my automatic transmission were likely dead.
Also check the planetary pinions, the sun gear, and both the front and rear internal gears for tooth damage. Finally, check the condition of the engine’s two motor mounts. If one or both of the motor mounts are damaged, the engine will cause the transmission to shift, which will in turn cause the transmission to produce noise.
The Turbo 350 was known as a durable transmission and was used extensively by GM. However, over time the Turbo 350 will develop problems, as with any type of transmission, but troubleshooting this transmission is easier than many other types due to its basic design.
350 Turbo Transmission Troubleshooting. by John Stevens J.D. The Turbo-Hydramatic 350, commonly referred to simply as the “Turbo,” was a three-speed automatic transmission first produced by General Motors in 1969.