Do you need a compressor to change struts?
To change the struts (if you don’t buy assembled ones) you will also need a spring compressor and often some means of holding the strut shaft while torquing the upper nut (without scratching the strut shaft).
Are there different ways to install gas struts?
As you can see, gas struts are everywhere, and you might think that different gas struts for different situations are built in different ways. Thankfully, struts are designed so that they operate pretty much along the same lines, so if you know how to install one, you should be able to install them all.
Can a spring pop out of a strut?
If the spring is separate from the strut, a spring compressor is required to compress the spring for removal and installation. If you don’t know what you’re doing, the highly compressed spring could pop loose and cause a traumatic injury. Struts that come as assemblies are much easier to replace since the spring is part of the assembly.
How long does it take to replace a pair of struts?
A pair of strut assemblies can be replaced by the average DIY mechanic in under two hours. But if the spring is separate, it’s best to let the professionals handle the replacement.
It’s recommended that the beginner forego attempts to compress the spring on the old strut using a spring compressor or spring clamps. This method is used to save money by salvaging the old spring and installing it on the new strut, but if you don’t have your own strut compressor, it will run you $700.
Which is the best strut spring compressor tool?
The ABN 11.5” Inch Strut Spring Compressor Tool features a hardened center screw and forged hooks which provide maximum toughness and longevity. It conveniently locks into place which makes spring compression a lot safer. This tool has a wide compatibility range making it very versatile.
How to replace your own shocks and struts?
How to replace shocks and struts 1. Check whether you need a spring compressor. On many cars, the struts/shocks and springs are interrelated or… 2. Securely raise one side of the car. If you’ve got access to an actual lift, great. Driveway DIYers everywhere are… 3. Remove the wheel and extract
Where do you put a spring compressor in a car?
If a spring compressor is required for your job, this is where you’d use it. There should be three bolts holding the bottom of the strut in place, which you can loosen with a socket wrench. Up top, the strut extends inside a strut tower with a serious bolt inside the engine compartment.