How to remove fuel filter from ve injector pump?
• Remove the fuel pipes between the filter and injector pump. • Remove the fuel filter and bowl behind the pump. The fuel filter is out but there’s still a long way to go • Remove the remaining fuel pipes from the top of the injector pump. • Release the throttle cable end from the pump lever. • Drain the radiator water but…
Who are the editors of diesel distributor fuel injection pumps?
Diesel distributor fuel-injection pumps Diesel-engine management Technical Instruction Published by: © Robert Bosch GmbH, 1999 Postfach 300220, D-70442 Stuttgart. Automotive Equipment Business Sector, Department for Automotive Services, Technical Publications (KH/PDI2). Editor-in-Chief: Dipl.-Ing. (FH) Horst Bauer. Editors: Dipl.-Ing.
Is it possible to replace one fuel injector?
Although fuel injectors are individual, they are designed to work as part of a team with the other injectors. So if you’re wondering if you can replace just one injector or all, the answer is almost always to replace them ALL.
What causes a fuel injector to stop delivering fuel?
An injector becomes clogged with fuel varnish deposits and fails to deliver its normal dose of fuel when it’s energized, or. Fuel pressure to the injector drops below specifications because of a weak fuel pump, plugged fuel filter or leaky fuel pressure regulator.
When do you need to replace the fuel injector?
If the coil on the fuel injector is good, you should see a resistance somewhere around 12 Ohms. If the coil has burnt out, you will see a reading of 0 Ohms (Short Circuit), or ~ Ohms (Open Circuit). If this is the case, the you will need to replace the fuel injector.
How to remove fuel injectors from Holden VE.?
13) Slowly and carefully remove the fuel rail and injectors as a single assembly, from the intake manifold. To do this, work you way around the fuel rail, incrementally pulling each injector from the manifold. Be careful not to pull the injectors from the fuel rail, as this will result in fuel spillage.
How to get fuel to the fuel distributor?
You need to remove the relay and put a jumper wire from terminal 7 to 8 in the relay connector so that the fuel pump runs continuously then press down on the air flow meter plate and see if the injectors screech as fuel passes through them as you press the plate all the way down. JACUSTOMER-swbdvutu- : ok i am at the relay eurotec :
How do you line up a fuel injector?
9) Line up the fuel injector so as the wiring plug is back away from you, and that the clip guides on the fuel injector are above the fuel rail. 10) Slide the fuel injector mounting clip over the fuel injector, and adjust the fuel injector and clip to ensure that the clip clips over the fuel rail mounting flange.