How to fix slow fill on Mercedes Benz?
Get a 10, 11 and 12 mm socket and pliers for removal of the vacuum line clamps. You don’t have to completely remove the wheel liner. Simply remove the 3-4 screws facing the rear of the car in the liner and fold the liner halfway to get access to the caniser.
What should I do if my gas pump keeps stopping?
Angling the fuel nozzle into the fill pipe differently usually does the trick. i.e. Holding the handle up instead of letting it hang down, or rotate it a bit in the fill tube mouth. Also, make sure the compression cuff around the nozzle is fully in contact with the mouth of the fill tube, and compressed against it. Like | 1 Save john_g 12 years ago
How do you fill a Mercedes Benz canister?
Simply remove the 3-4 screws facing the rear of the car in the liner and fold the liner halfway to get access to the caniser. Once the liner is out you can easily remove the canister and the evap vacuum lines.
Where is the gas cap on a Mercedes Benz?
It is located inside the rear wheel well on the gas cap side. Jack up the car by the rear tire (on the side) and remove the tire. Get a 10, 11 and 12 mm socket and pliers for removal of the vacuum line clamps. You don’t have to completely remove the wheel liner.
Get a 10, 11 and 12 mm socket and pliers for removal of the vacuum line clamps. You don’t have to completely remove the wheel liner. Simply remove the 3-4 screws facing the rear of the car in the liner and fold the liner halfway to get access to the caniser.
Is there a problem with the Mercedes Benz gas tank?
Filling up the tank should never be an issue, unless its running down the side of your car; LOL. Here’s the problem with your car. Many Mercedes models from 2003 – 2009 have a known gas tank issue where a hole develops on top of the tank. The only solution is getting the gas tank replaced.
Is there any way to get Mercedes Benz reimbursement?
Whether MB USA informs anyone personally by letter or not, printing this and providing it to your dealer should be sufficient to get the ball rolling on any reimbursement or repair without getting the run around. This is the letter from Mercedes Benz referenced above.
Simply remove the 3-4 screws facing the rear of the car in the liner and fold the liner halfway to get access to the caniser. Once the liner is out you can easily remove the canister and the evap vacuum lines.