How do you reset the airbag on a Mercedes?
Instruction on How to Reset the SRS Light on a Mercedes Benz:
- Locate the fuse panel cover and remove it.
- Put the key into the ignition and turn it to the “Run” position.
- Check your owner’s manual for what the codes mean.
- Unplug the scan tool and put the fuse panel cover back in place.
Is the front passenger airbag disabled in Mercedes?
Mercedes Front Passenger Airbag Disabled Enabled See Oper. Manual Mercedes-Benz vehicles including E, C, S, CLS, ML, GL, R, G Class, may display a warning message stating front right SRS has malfunctioned and needs to be repaired. Front Passenger Airbag Disabled See Oper.
What causes the Mercedes Sprinter airbag warning light to stay on?
Running the engine with low coolant level may cause the engine to overheat, resulting in damage. Stop as soon as possible, switch off the ignition to allow the engine to cool, then add coolant. Description: The Mercedes Sprinter airbag warning light stays on when a fault has been detected with the airbag system.
Can a Mercedes airbag be reset by myairbags?
The best part of having your Mercedes original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
What is the cause of a Mercedes airbag fault?
The cause is the cable routing under the passenger seat. The wire was dressed from the factory such that the cabling to the connector was under tension. Res. of Ign. Circuit containing R12-1 (Drivers ETR Ign. Squib too low). Component of control module WSS is faulty.
The best part of having your Mercedes original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
The cause is the cable routing under the passenger seat. The wire was dressed from the factory such that the cabling to the connector was under tension. Res. of Ign. Circuit containing R12-1 (Drivers ETR Ign. Squib too low). Component of control module WSS is faulty.
What happens to your airbag control module in an accident?
Send your airbag control module to MyAirbags and save time, money and not having to deal with a dealership! During an accident, seat belt retractors and tensioners are deployed and will lock up by their gas charges, similarly to how airbags are deployed in a collision.
How to reset SRS / airbag light on Mercedes Benz?
Find the port that fits the OBD cable and plug the scan tool’s cable into this port. 2. Put the key into the ignition and turn it to the “Run” position. This is the position just before the engine starts. Look at your OBD scan tool and write down the codes it displays. 3. Check your owner’s manual for what the codes mean. 4.