How much does it cost to repair a car alternator?
Alternators can average anywhere from $100 to $350 depending on make and model. Most vehicles will fall into the $350-400 range for the total job of alternator replacement if no other parts need to be replaced. If the serpentine belt gets tacked on, add another $20 to $50 to your bill.
How do you replace an alternator on a Mercedes Benz?
Release tension on the alternator belt. Turn the center tension pulley clockwise with a socket wrench. This will create slack in the belt. Slide the belt off the alternator. You will need to remove the belt from all of the other components on the system as well. Remove the electrical connector on the back of the alternator.
How do you remove a belt from an alternator?
Release tension on the alternator belt. Turn the center tension pulley clockwise with a socket wrench. This will create slack in the belt. Slide the belt off the alternator. You will need to remove the belt from all of the other components on the system as well.
How long does an alternator last in a car?
It is designed to last for at least 60,000 miles. When the alternator dies, the first sign is the battery light illuminating on the dash. When the battery light illuminates, it is, ironically, usually not just the battery.
What should I do if my alternator is making noise?
There are two bearings in the alternator, both of which can be bought at M/B. 43sqd, so what can be done to confirm the bearing failure? other than the noise I heard? and without pulling the alternator out.
Where to go to replace an alternator on a Mercedes Benz?
Followup from the Pelican Staff: You can remove them and go to hardware store and match them up with a gauge. With your vehicle info handy, give The Pelican Parts parts specialists a call at 1-888-280-7799. They can figure out what part or repair kit you need.
What to do if your alternator goes out?
The first thing to check is the battery light on the instrument cluster. This light bulb is part of the alternator field circuit; if it burns out the alternator will not charge. Simply turn the key on and see if it illuminates briefly then goes off. If the light does not illuminate, you’ll need to replace it before continuing.
How to change the coolant in a Mercedes Benz?
Locate the tensioner and using the Torx driver turn it counter-clockwise 45 degrees. You can now slip the belt off the tensioner and install the new one. You can also lock the tensioner into the open position if you need both hands to install the new belt.
How to replace a Mercedes Benz air filter?
You will need to remove the two air inlet ducts (red arrows) as well as the front engine cover (yellow arrow) to get access to the air filter housing on top of the engine. Remove each duct by compressing them towards the engine (red arrow) and slipping them off the air inlet. With the ducts off remove the front engine cover.