How do you remove a soft close toilet seat?
Open the lid and lift the toilet seat, then apply outward pressure to the ends of both hinges to release them. Once the toilet seat and lid have been removed, place them on a flat surface with the bottom of the seat facing up and the hinges pointing toward you. The process of removing the soft-close dampers will also differ by brand and style.
What to do if your Mercedes convertible top is blown?
If it is blown, replace it with a new fuse with the same ampere rating. Check the convertible top relay as well. Swap it with a known working relay that is identical. You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run. Replace the convertible top relay if necessary, PN 0025421319.
When is it time to replace the fuel suction Dampner?
If you are experiencing erratic acceleration, it may be time to replace the fuel suction dampner. Follow these easy step-by-step instructions. If your acceleration is muted the warm up regulator may be broken or on its way to being kaput. Replace it with this tech article
Why do I need to adjust the soft close on my toilet?
This prevents them from slamming down, which could damage the toilet seat and hinges or wake sleeping members of the family. Dampers control the soft-close action, and these may need to be adjusted or replaced if the lid suddenly starts slamming closed.
What’s the best way to remove a cylinder head bolt?
One way to remove really tight head bolts is with a breaker bar. This method allows for more leverage than a traditional ratchet and socket. Step 1: Use impact force. You can hit the center or the head of the bolt with a chisel or punch to try to free the corrosion between the threads.
How do you remove a main lift cylinder?
To remove the main lift cylinders, you will need to remove the spring loaded, metal trim panel on top (“top case plate”), the welting inside the door jamb, and the trim panels around the rear compartment area. But first, remove the clip and upper mounting pin of the main cylinders and push the cylinders in all the way.
What can I do to keep bolts from falling off?
While these devices do prevent the nut from falling off the bolt, they generally do not help the joint maintain the specified clamp force. Prevailing torque nuts. Nylon or metal inserts inside a nut (sometimes called a “lock nut”) can add extra friction to prevent loosening.
Can a torque to yield head bolt be removed?
Torque-to-yield head bolts stretch when they are torqued to allow them to tighten properly and repeated application can cause the head bolt to break. Removing the head bolts can seem like a daunting process but with care, following all the above steps, it can be done.