Where are glow plugs on a Dodge Sprinter?
Dodge Mercedes Sprinter (diesel engines). Glow plug resistance test from Glow Plug Control module located between fan and engine. 2007+ models. Resistance should be around 2 ohms only. Test performed after OBDII scanner showed codes P0672 P0673 P0674 Buy Glow Plugs here: http://www.amazon.com/Piece-Bosch-Plu… Loading…
What does the code p0673 mean on a glow plug?
The code P0673 tells you that something in the glow plug circuit is faulty causing the glow plug on cylinder #3 to fail to heat up. The entire circuit must be checked to locate the fault. Note: If a P0670 trouble code is present along with this DTC, carry out P0670 diagnosis before diagnosing this code.
How are the cylinders numbered on a sprinter?
The cylinders on the Sprinter are numbered from #1-6 in the following order (1, 2, 3 are passenger side; 4, 5, 6 are driver side): For reference, the following picture shows the general location of the glow plugs, the fuel filter and the turbo resonator.
What does the code p0673 mean on cylinder 3?
The code P0673 tells you that something in the glow plug circuit is faulty causing the glow plug on cylinder #3 to fail to heat up. The entire circuit must be checked to locate the fault.
Dodge Mercedes Sprinter (diesel engines). Glow plug resistance test from Glow Plug Control module located between fan and engine. 2007+ models. Resistance should be around 2 ohms only. Test performed after OBDII scanner showed codes P0672 P0673 P0674 Buy Glow Plugs here: http://www.amazon.com/Piece-Bosch-Plu… Loading…
The cylinders on the Sprinter are numbered from #1-6 in the following order (1, 2, 3 are passenger side; 4, 5, 6 are driver side): For reference, the following picture shows the general location of the glow plugs, the fuel filter and the turbo resonator.
Are there any problems with the Sprinter van?
Overall, Sprinters are highly reliable vehicles. As a result, they are popular among businesses and organizations for commercial use, even being used by emergency services. Despite their efficiency and reliability, there are issues that befall Sprinter vans. In this blog, we’ll explain a common problem with glow plugs and how to overcome it.
Why are the glow plugs on my diesel engine not working?
Glow plugs are an essential component for a cold start of every diesel engines. These are, in essence, a strong electrical heaters. As the car ages the glow plugs can fail. The symptoms are a long cranking time and a very rough running in the first several minutes.
Can a worn out glow plug cause a check engine light?
A worn out glow plug will cause a check engine light. In addition to the CEL, you will likely see the glow plug coil light on your dash after the engine turns on – it turns off after 10 seconds or so.
A worn out glow plug will cause a check engine light. In addition to the CEL, you will likely see the glow plug coil light on your dash after the engine turns on – it turns off after 10 seconds or so.
Where can I get cheap glow plugs for my Mercedes?
I saved some money by going to getmercedes.com which is a Mercedes dealer willing to sell at reduced prices ($57).
How to replace glow plugs on Mercedes injection pump?
Keep the lines together as a set and place them in a clean area. Cover the injection pump outlets with a towel or tape them over to keep debris out. 2. Remove the 8mm nuts that hold the wires to the glow plugs. The wires have a tendency of spinning when you turn the nut.
How often do you cycle glow plugs on Mercedes?
The engine turns over as fast a usual, starts on the second or third try, starts right up if I cycle the glow plugs two or three times. After its warm, starts right up. Sounds like glow plugs, lets get started.
Where are the glow plugs on the Mercedes E320?
The plug was made by NGK, and indicates it is Mercedes Part No. A001-159-57-01, NGK Part No. CZ302, 7 volt. Called Mercedes Tysons Corner and was told the replacement part is Mercedes No. A001-159-66-01 for my ’08 E320.