What kind of pump does a PSE A-37 have?
… The PSE (A-37) has a vacumn pump to operate the door, boot and petrol filler locks. Plus rear demister relay and ARA control model if fitted. It comunicates with the DAS thru the CAN from the MFC unit. I just took mine out to check for moisture.
What should I do if my foam pump breaks?
Just wash it clean gently with warm water and a toothbrush. The other problem is when one or both mesh ends are torn. The plastic mesh is fused on with heat, but we don’t need heat to do the repair. Find some sheer fabric curtains at the thrift store.
What’s the best way to remove a PSE?
7. using a small flat screwdriver to push detents remove base by lifting it as you go around. 11. clean if required using nylon toothbrush. 13. put unit back into housing. Ensure vac tubes line up with top holes 17. slip into foam box NOTE: some people have wrapped a plastic bag around whole lot here.
Where does the bead go on a foam pump?
Here’s how the bead sits, inside the mixing chamber, and against the end of the spring, as shown in both the exploded view and the in-use view. You won’t be able to reach the column where the bead goes. You may have to line it up and drop it in a few times, but you’ll get it.
… The PSE (A-37) has a vacumn pump to operate the door, boot and petrol filler locks. Plus rear demister relay and ARA control model if fitted. It comunicates with the DAS thru the CAN from the MFC unit. I just took mine out to check for moisture.
7. using a small flat screwdriver to push detents remove base by lifting it as you go around. 11. clean if required using nylon toothbrush. 13. put unit back into housing. Ensure vac tubes line up with top holes 17. slip into foam box NOTE: some people have wrapped a plastic bag around whole lot here.
What does the PSE do on a Mercedes Benz?
The PSE (A-37) has a vacumn pump to operate the door, boot and petrol filler locks. Plus rear demister relay and ARA control model if fitted. It comunicates with the DAS thru the CAN from the MFC unit.
What does a PSE spray do to a car?
1, a spray that will keep the parts from rust/moisture, and cleans the circuits, but is not hardened. 2, the same thing, only that when this dries it gets getting hard and like a film/coating lying over the board. That will protect against water/moisture forever.