What does c1142 mean on ABS ESP light?
Rating is available when the video has been rented. This feature is not available right now. Please try again later. If your ABS brakes turn on randomly on your ML320 ML430 or ML500 and your BAS ESP light is on and you have code C1142 it’s more than likely your Lateral Acceleration Sensor.
What is the fault code for a Mercedes heater?
P0135 O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1) P0136 O2 Sensor Circuit Malfunction (Bank 1 Sensor 2) P0137 O2 Sensor Circuit Low Voltage (Bank 1 Sensor 2)
Why do my ABS brakes have code c1142?
If your ABS brakes turn on randomly on your ML320 ML430 or ML500 and your BAS ESP light is on and you have code C1142 it’s more than likely your Lateral Acceleration Sensor. If you have code C1142 check out my other video below to see how to replace it.
What is the fault code for the bank 2 sensor?
P0152 O2 Sensor Circuit High Voltage (Bank 2 Sensor 1) P0153 O2 Sensor Circuit Slow Response (Bank 2 Sensor 1) P0154 O2 Sensor Circuit No Activity Detected (Bank 2 Sensor 1) P0155 O2 Sensor Heater Circuit Malfunction (Bank 2 Sensor 1)
Where are the fault codes on a Mercedes Benz?
Cut off line to Pin 11 (BNYE), Pin 12 (BU) and line to Pin 4 (YE) approx. 160mm after the connector (14-pin) of the frame floor system (FFS) wiring harness to the steering column tube (N80) and unpin from steering column tube module connector. Slide back the flexible cable set jacket and fix in place for this purpose.
What is the fault code for a D2B ring?
N1141 MCS fault code: Set-actual configuration of D2B ring differs from actual. N1241 CD fault, CD can not be read. 9260 SRS: resistance in drivers airbag too high. Replace Wiring. Please post a link to this string of posts in the Useful W163 Documents and the DIY Stickys at the top of this forum. done. good stuff.. Anyone know anything about it?
What is fault code b1859 on Mercedes Benz?
There is a known issue with poor connection in the lines to the steering column module that connect to the airbag for fault code B1859. There is a repair that involves repairing the wiring in the loom to this module as the SRS control module sees too high a resistance to the drivers airbag.