What to do when SRS light comes on?
Hit Read on the scanner. Once the codes display on the LCD screen, hit erase. It’s that easy. Note that if the problem that caused the AirBag / SRS light to come on in the first place is not resolved, the Airbag / SRS light will come back on. What does it mean when the SRS light is on?
What does the SRS light mean on a Mercedes Benz?
What does SRS light mean? SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system.
Where is the SRS scanner on a Mercedes Benz?
Plug in this scanner on the OBD II port found under the dashboard on the driver side. Hit Read on the scanner. Once the codes display on the LCD screen, hit erase. It’s that easy. Note that if the problem that caused the AirBag / SRS light to come on in the first place is not resolved, the Airbag / SRS light will come back on.
What does SRS stand for in airbag warning light?
SRS stands for Supplemental Restraint System, any it is refered as the SRS or Airbag Warning Light. This could be because the AirBag Control Unit is not programmed correctly. SRS Control Unit is not parameterized or as some may refer taught-in.
How do you turn off the SRS light?
Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice.
What does the SRS light on the dashboard indicate?
But one of the most important signals may be a mystery until it is lit up on your dashboard: the SRS light. WHAT IS THE SRS LIGHT? The Supplemental Restraint System (SRS) is the technical name for the system that controls the airbags and automatic seatbelt restraints.
Where is the reset button on a Honda SRS light?
To do so, you will be “shorting” the system in order to reset the light. Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash.
Which is the best scanner to reset the SRS light?
Our favorite scanner that will read and reset your SRS / airbag light is the iCarsoft i980 for Mercedes-Benz which will retrieve the SRS light but also the check engine.