What happens if there is no spark at the coil?
If there is no voltage at pin 3 of C2, the ignition switch may be bad (both terminal 15 on the coil and pin 3 of C2 are powered from pin 15 of the ignition switch).
What happens if there is no external signal to the ignition coil?
With no external signal to the coil negative primary post, voltage would travel through the ignition coil windings without inducing any secondary spark. A switch, or signaling device, triggers an interruption in the circuit.
Why is there no spark in my ignition?
An ignition module requires some type of external input in order to activate. If your vehicle stalls unexpectedly during operation and will not start again, it is likely because of loose or corroded electrical connections in the ignition module. In this case, check the switch, clean oxidized terminals, and replace broken wires if necessary.
How can I tell if there is no spark at the spark plug?
Watch the plug to see if you are getting a spark. If you are getting spark, skip to the next section to check for fuel. If you are not getting spark at the plug, test again at the coil tower. if you get spark at the coil but not the spark plug, check the Distributor Cap and Rotor.
What to do if there is no spark at the ignition coil?
Check for voltage output at the ignition coil. Disconnect the ignition coil wire from the distributor and install the spark tester to the wire and ground the tester to the engine. Crank the engine for a few seconds. If there’s spark, the problem is with the distributor cap or rotor.
Why is there no spark at the coil axle?
If there’s no voltage, check the wire between the ignition switch and the coil and, if necessary, the switch itself. If there’s voltage, the problem may be with the pickup unit. If the pickup is good, then the problem may be with the ignition control module.
What happens if your engine has no spark?
Dan Ferrell writes about do-it-yourself car maintenance and repair. He has certifications in automation and control technology. Worn out spark plugs will fail to ignite and start your engine. An engine with no spark produces a no-start condition.
Why is there no spark at the tip of the spark tester?
While the engine cranks, you should see a bright, blue spark at the tip of the spark tester. If there’s a good spark, including the rest of the cylinders, the ignition system is working properly. If only one or a few cylinders have a weak or no spark, the problem is in the secondary side of the system.