How do you reset the check engine light on a 2006 Mazda3?
Turn The Ignition On And Off You just have to put the key into the ignition and turn it on and off for three times in a row with the gap of a second in each step. After you are done, drive the car to see if the light is reset.
What’s the problem with my Mazda 3 manual?
Mazda 3 2006 manual, revs… Mazda 3 2006 manual, revs are low in idle and engine cuts out. Just replaced battery and then this started happening, also just had a major service a week ago at 80,000 kms. I’ve had the car from new and never had a problem with it ? ? Any help would be appreciated thanks Experience: 19 yrs. experience.
Why are the revs low on my Mazda 3?
Mazda 3: Mazda 3 2006 manual, revs are low in idle and engine… Mazda 3 2006 manual, revs… Mazda 3 2006 manual, revs are low in idle and engine cuts out. Just replaced battery and then this started happening, also just had a major service a week ago at 80,000 kms.
Is it normal for a Mazda 3 to idle at 750?
The car is suppose to idle at 750. That is normal for it. 1k seems really high except for on a cold start. But once it is warmed up it should be at 750. now 500 is way to low and will stall you out. Have you checked your MAF wires? One or more of them may be pulled. Also, have you tried running some fuel system cleaner through your car?
When does idle surge start on Mazda 6?
When driving the car and coasting in neutral the rpm will drop to 900 and most of the time hold or sometime have a light flicker. Strong surges or drops only seem to happen if I am traveling slowly, less than 15 mph, or stopped. I’m not really sure about how well that statement holds up but will experiment more tomorrow.
Mazda 3 2006 manual, revs… Mazda 3 2006 manual, revs are low in idle and engine cuts out. Just replaced battery and then this started happening, also just had a major service a week ago at 80,000 kms. I’ve had the car from new and never had a problem with it ? ? Any help would be appreciated thanks Experience: 19 yrs. experience.
Mazda 3: Mazda 3 2006 manual, revs are low in idle and engine… Mazda 3 2006 manual, revs… Mazda 3 2006 manual, revs are low in idle and engine cuts out. Just replaced battery and then this started happening, also just had a major service a week ago at 80,000 kms.
The car is suppose to idle at 750. That is normal for it. 1k seems really high except for on a cold start. But once it is warmed up it should be at 750. now 500 is way to low and will stall you out. Have you checked your MAF wires? One or more of them may be pulled. Also, have you tried running some fuel system cleaner through your car?
What to do if your Mazda 3 has a vacuum leak?
If that does not resolve the concern then you may have to disconnect the battery and hold your foot on the brake pedal for 1 min. This will reset the module. Clean and reconnect the cables and recheck. With the engine running, make sure there are no vacuum leaks and everything is connected.