Why is my Mazda 6 stalling at junctions?
Thanks for the reply – I’ve also stumbled across those threads when I’ve been looking into this problem. As far as I can tell, suction control valves (scv) seem to only be present on cars with diesel engines though, so might not relevant to my problem as mine’s a petrol.
What kind of spark does a Mazda 3 have?
I check the spark by taking out all the spark plugs, then holding one after the other against the metal block and checking for spark while someone turned the ignition. All 4 plugs showed spark, and they looked strong with a bluish spark color.
Why is my Mazda 6 cranking but not starting?
There are a lot of issues that can cause your 6 to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code. It is definitely worth it to use an OBDII scanner to check and see if the engine has thrown any trouble codes.
What kind of engine does a Mazda 3i have?
I have a 2005 Mazda 3i 2.0L 5 speed manual. I bought it back in April with 92,000 miles and it now has 110,000 miles. It has a catback straight pipe exhaust and the previous owner said the engine was swapped, due to a timing chain failure on the previous one.
How can I tell if my Mazda 6 has no spark?
You have no spark did you check to see if the fuel pump activates when you switch on the ignition ,should activate for 2 seconds and activate again when you crank the engine . I did check for codes and it is giving a P0335 code. I checked wires leading to the sensor and also just replaced the sensor to be 100% sure. Still no spark.
What kind of engine does a Mazda 6 have?
2004 Mazda 6, 2.3L… Engine cranks but no spark… was running before I replaced alternator after first symptoms led to Mazda repair questions? Ask mechanics for answers ASAP By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. 2004 Mazda 6, 2.3L…
I check the spark by taking out all the spark plugs, then holding one after the other against the metal block and checking for spark while someone turned the ignition. All 4 plugs showed spark, and they looked strong with a bluish spark color.
Why does my Mazda 3 not want to start?
You’re getting oil on your spark plug; replace the valve cover gasket, it isn’t very hard, basic tools are needed, and a valve cover gasket kit from a dealership and some gasket maker silicon. It could just be a severe enough leak going through #4 to not want to start.