How do you flash the headlights in a Mazda?
To flash the headlights, pull the lever fully towards you (the headlight switch does not need to be on). The headlight high-beam indicator light in the instrument cluster illuminates simultaneously. The lever will return to the normal position when released. The coming home light turns on the headlights (low beams) when the lever is operated.
When to turn off leaving home light Mazda 6?
When the ignition switch and the headlight switch are in the following conditions, the headlights will illuminate when the transmitter unlock button is pressed and the vehicle receives the transmitter signal. The headlights turn off after a certain period of time has elapsed (30 seconds). Operation of the leaving home light can be turned on or off.
What does self leveling headlights on a Mazda do?
Modern Mazdas come with many adaptive technologies, one being self-leveling headlights. This technology allows the headlights to remain level regardless of the vehicles pitch. When lowered however, the car interprets this change in suspension geometry and adjusts the headlights, often aiming them straight into the ground.
How does the auto light control work on a Mazda?
Auto-light control (Some Models) When the headlight switch is in the position and the ignition is switched ON, the light sensor senses the surrounding lightness or darkness and automatically turns the headlights and other exterior lights on or off.
How do you adjust the headlight beams on a Mazda 3?
Tire pressure is at specification. The reflectors for the low and high beams are an integrated unit. Therefore, perform the headlight aiming adjustment on only the low beam. 1. Point the headlight beams to a wall and verify that the headlight beams are as shown in the figure.
Is the Mazda 5 the same as the Mazda 3?
Like the BMW 5-Series, the Mazda 5 is basically the same as a Mazda 3 (or 3-Series), and a little smaller than the Mazda CX-7 (or 7-Series). And, being mechanically identical to it’s smaller Mazda 3 cousin, the procedures used to adjust the headlights are almost identical.
What should I do if my headlight is not in the correct position?
Verify that the elbow point of the headlight is in the position indicated on the screen. If the elbow point is not in the position indicated on the screen, perform the following adjustment: Insert a Phillips driver into the position shown in the figure and adjust the headlights. 1. Disconnect the negative battery cable.. 2.
Can you adjust the headlight aiming with cargo?
If the headlight aiming is adjusted with cargo in the vehicle, it may not adjust correctly. Adjust the headlight aiming with the vehicle under the following conditions: Tire pressure is at specification. The reflectors for the low and high beams are an integrated unit. Therefore, perform the headlight aiming adjustment on only the low beam. 1.