How to adjust the headlight level on a Mazda 6?
Start the engine to charge the battery. 9. Turn on the lower-beam headlight. 10. Set the headlight leveling switch to 0 position. 11. Adjust the headlights by turning the adjusting screws as shown in the figure. Loosen the screws first, then tighten them.
How to tell if a Mazda headlamp is at fault?
Trace in RED the portion of the circuit below that you suspect could be at fault. The LEFT HIGH BEAM HEADLAMP does not work in the High Beam Position. Both lamps function normally in the low beam position. The tail lamps function correctly. 3. Trace in BLUE the portion of the circuit below that you suspect could be at fault.
How to make a Mazda head lamp work?
1. Draw in GREEN the HEAD LAMP CONTROL circuit from the battery to ground. 2. Draw in RED the LOW BEAM circuit from the battery to ground. 3. Draw in BLUE the HIGH BEAM circuit from the battery to ground. L-1 Page 4 V Y X W Z MAZDA HEAD LAMPS WORKSHEET#3 1.
How to get a Mazda 6 workshop manual?
With this Mazda 6 Workshop manual, you can perform every job that could be done by Mazda garages and mechanics from: Document Properties… An error occurred while loading the PDF. Enter the password to open this PDF file.
How to set the headlights on a Mazda 6?
Set up a screen as shown in the figure below for aiming the headlights. 2. Adjust the tire air pressure to the specification. 3. Position the unloaded vehicle on a flat, level surface. 4. Seat one person in the driver’s seat. 5. Position the vehicle straight ahead and perpendicular to a wall. 6. Set the headlights 3 m {10 ft} from the wall. 7.
What kind of headlight does a Mazda 3 have?
Here’s a diagram of the OEM headlight assembly for 2010-2011 Mazda 3 models and a list of all these parts: Each Mazda headlight assembly has its own unique design, but all halogen headlight assemblies work the same way. There’s a reflector in the headlight housing.
Trace in RED the portion of the circuit below that you suspect could be at fault. The LEFT HIGH BEAM HEADLAMP does not work in the High Beam Position. Both lamps function normally in the low beam position. The tail lamps function correctly. 3. Trace in BLUE the portion of the circuit below that you suspect could be at fault.
How much does it cost to make a Mazda headlight?
The quick and straight answer is: it depends. The Mazda headlight assembly cost varies between models. Some Mazda headlight assemblies are more complex than others. For example, part number GJS1-51-031C (OEM headlamp for 2014-2017 Mazda 6 models) has a simpler design than part number FF16-51-041C (OEM headlamp for 2009-2011 RX-8 models).